Safety Angel Water Immersion Alarm Manual - page 5
5
V Charging
1. Charging the Base Unit
The New Safety Angel Base Unit uses a rechargeable lithium battery. When it is time to charge the
unit simply connects the power adaptor provided, the Base Unit will begin charging automatically.
When charging the Base Unit icon
is on. When charging is complete the bolt icon is off
2. Charging the Bracelet
The Bracelet uses a rechargeable lithium battery that when run down can’t switch the Bracelet on;
it needs to be recharged by means of these following steps. This should always be done when you
first purchase the product before use.
2.1) Connect the Base Unit to the Bracelet by means of the special connector (supplied).
Use a sharp pointed object to open the plastic cover. Insert the small connection end into the
charge aperture, and the other end into the charge connect aperture on the Base Unit.
2.2) Turn Base Unit ON and commence charging of the Bracelet. Whilst charging the bolt
icon in the Bracelet will be on.
After it is fully charged, the bolt icon will be removed. The full
charge time is 4 - 6 hours.
2.3) It is recommended to plug the Base Unit into the mains supply whilst charging the
Bracelet using the supplied adapter cable. However, the Bracelet can also be charged from Base
Unit battery power also. (Important: this is only for emergency use, as Base Unit battery may not
be fully charged.)
2.4) Ensure the plastic cover to the connection point to the base of the Bracelet is replaced
correctly.
Very important: For long time no use, both Bracelet and Base Unit must be recharged one