Safety Technology International STI-V34104 Manual

Page of 8

Download

Print this page

Bookmark us

- 1 -

4-Channel Voice Receiver

STI-V34104

HOW THE PRODUCT WORKS

The 4-Channel Voice Receiver is a multipurpose long-range receiver that works

with a wide range of STI Wireless Alert Series sensors. Most products can

achieve up to 1,000’ receiver range (line of site). Four zone indicators light up

to indicate a sensor has triggered. Selectable tones and voice messages are a

key feature. Sensors have default messages or program your own by choosing

up to four words or tones from a preprogrammed list. All voice messages are

available in English or Spanish. Receiver is intended for indoor use only.

EASY STARTUP

Install batteries in sensor,

plug in receiver and listen

to instructions.

We protect the things that protect you.

1 2 3 4 5 6 7 Next › »

Summary of STI-V34104

Page 1
- 1 - 4-channel voice receiver sti-v34104 how the product works the 4-channel voice receiver is a multipurpose long-range receiver that works with a wide range of sti wireless alert series sensors. Most products can achieve up to 1,000’ receiver range (line of site). Four zone indicators light up to...
Page 2
- 2 - before you start review detailed product specifications (fig. 1 and 2) antenna jack · internal antenna with product · use external for maximum range volume control lamp controller output · works with sti lamp controller (sti-30104) · 3.5mm mono jack, center negative · 12vdc, 75ma 3 sec power s...
Page 3
- 3 - zone programming procedures only receives wireless signals from the sti wireless alert series products. Program up to 4 sensors or keyfobs. Does not allow programming into an occupied zone. Cannot program the same sensor into more than one zone. The unit will state, “please change to normal mo...
Page 4
- 4 - programming 1. Plug in receiver. 2. Listen to verbal voice commands. They will guide you through programming. Notes · firmly press acknowledge button at any time to stop voice. · make sure battery is installed in sensor. · each sensor provides an initial sound (dong). (see chart 2 below) · eac...
Page 5
- 5 - advanced programming 1. Make sure switch is in program mode 2. Press zone/message selection button intended for sensor advanced programming 3. Move dip switches to correct position for selected word 4. Press zone/message selection button to accept word (repeat for up to four words/tones) cauti...
Page 6
- 6 - 3 4 5 6 7 8 english spanish 0 0 0 1 0 0 4-note chime carillon de 4 notas 0 0 0 1 0 1 8-note chime carillon de 8 notas 0 1 1 0 1 0 alert alerta 0 1 1 1 0 1 assistance asistencia 1 1 0 0 0 1 barn granero 1 0 1 0 1 1 basement sotano 0 0 1 0 0 1 bell campana 1 1 0 1 1 1 button boton 0 0 1 0 1 0 bu...
Page 7
- 7 - delete sensor 1. In program mode simultaneously press and hold the acknowledge button and zone/ message selection button for three seconds. 2. Successful when receiver states, “zone [number] is empty,” and green led is off. Low battery / tamper / out of range alert the 4-zone led light indicat...
Page 8
- 8 - inst. V34104 sept2015 printed in usa important notice this product has been tested and complies with the specifications for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential i...