Ucit pro-4 channel installation manual 06/15 version 2.0
1 this is a step by step guide that will walk you through installing the ucit pro-4 channel camera system. Basic wiring experience and knowledge is required at the minimum. Please follow each step , otherwise your system may not work properly. If you have any questions regarding the installation of ...
Notes and precautions please make sure power connections are clear to you before you make the connection. Please follow this guide step by step do not skip around. It is normally required to have a professional installer install these units. Keep dvr system away from liquids, heavy dust and dirt, fi...
Step 1: find a suitable location to mount the dvr in such a way that is accessible to the fleet manager. (to pull sd card and for troubleshooting) step 2: securely mount dvr (installers choice) by way of self-taping screws, zip ties, double sided tape etc. Step 3: run the gps and comm antennas (anyw...
Step 5: run camera cables with supplied 5 meter extension cables. Ensure proper connection, use electrical tape if needed. V - video output a - audio output 1. Camera 1 video input 2. Camera 2 video input 3. Camera 3 video input 4. Camera 4 video input step 6: before you make connections, remove fus...
Step 7: start the vehicle and make sure you see lights on the dvr near the sd card slot on the front. This will ensure a proper connection. On the side of the dvr you will see a little blue switch. Use a pen, screwdriver or something small to flip the switch to the right. This will activate the dvr ...
