Safety Vision SV-CLCD56B Quick Installation Manual - page 3
SV-CLCD56B/70B Quick Installation Guide
March 2007
SV-CLCD56B_70B QIG Ver.1.0.doc
3
SV-CBB-56-70 Control Box
A MAX-MIN AUTO TIME KNOB
—used with an
optional remote control device to set camera dwell
time in Scan mode (not typically used in
SV-CLCD56B/70B system installations)
B AUX OUT
—accepts the connector of an optional
audio/video output device (yellow/video, red/right,
white/left)
C AUX IN
—accepts the connector of an optional
audio/video input device (yellow/video, red/right,
white/left)
D POWER OUT
—provides power to an optional
peripheral device
E REMOCON
—accepts the connector of an optional
remote control device
F MONITOR
—accepts the connector of the monitor
cable
G MIR/NOR SWITCHES
—control the mirror/normal
image setting for the corresponding cameras
H CAM2
—accepts the cable connector for an optional
second camera and supplies power to the camera
I CAM1
—accepts the connector for the supplied
camera extension cable and supplies power to the
camera
J POWER IN
—accepts the barrel-type connector of
an optional power cable (not typically used in
SV-CLCD56B/70B system installations)
K POWER IN
—accepts the 4-pin Molex connector of
the control box system power cable
Optional Components
Optional components for the SV-CLCD56B/70B system
include a remote control device (Part Number SV-LCDB-
CP) for the monitor. In addition, devices other than the
components supplied with the SV-CLCD56B/70B system
(such as an additional camera) can be connected to the
system.
Typical Installation
SV-LCD56B/70B Monitor
1. Select a mounting surface for the monitor, which can
be mounted overhead or elsewhere in the vehicle
cabin (including on the floor or console).
The mounting surface should:
Be level, waterproof, ventilated adequately, and
capable of supporting the weight of the monitor and
mounting bracket
Not be close to a vehicle speaker (to prevent
interference from the speaker’s magnetic field)
Not be extremely hot or humid
2. Affix the monitor bracket to the mounting surface with
the supplied screws.
Installing the Monitor Bracket
3. Position the monitor in the monitor mounting bracket,
adjust the angle as necessary, and tighten the handle
screw.
Installing the Monitor in the Bracket