Quick installation guide f@st 5302 power dsl internet lan1 lan2 lan3 lan4 usb wlan wps fxs qig 253xxxxxx fast 5302_en.Book page 1 lundi, 25. Mars 2013 3:25 15.
2 f@st 5302 sagemcom thanks you for choosing the range of f@st 5302 routers while hoping that it will provide you with full satisfaction. F@st 5302 products adapt the adsl/vdsl function respectively on pots (itu g.992.1/3/5 - appendix a). F@st 5302 equipment include four ethernet interfaces (lan1 to...
3 f@st 5302 contents of the pack before you carry out the installation, make sure that the pack contains the following elements: item description 1 f@st 5302 router 2 mains adapter 3 adsl line cable used to connect your router to your telephone line 4 ethernet cable used to connect your router to th...
4 f@st 5302 safety instructions power supply source • do not cover the router’s mains adapter. • the router comes with its own mains adapter. Do not use another adapter. • this class ii adapter does not need to be grounded (earthed). The connection to the electrical network should comply with the in...
5 f@st 5302 connection connecting your router make the connections as shown in the diagram below. Rj11 rj11 line wall socket phone set mains adapter with its lead mains wall socket power reset wlan usb lan1 lan2 lan3 lan4 phone dsl wps pwr rj11 phone filter/spitter line line wall socket pstn line ph...
6 f@st 5302 connecting additional telephones make the connections as shown in this diagram. Router supervision you can monitor the router’s activity and status using the following sources: • status of the leds on the front and left panels of the router, • using the router’s built-in "dsl router" htt...
7 f@st 5302 adsl green steady adsl/vdsl up green blinking (slow) adsl/vdsl synchronisation in progress or down green blinking (fast) adsl/vdsl training and analysis phases internet off • power off or • the internet account must be configured or • bridge mode green steady the internet account is conf...
Button on the rear panel fxs off no fxs connection green steady fxs ready for tx/rx a call green blinking (slow) no recording green blinking (fast) call in progress button meaning wps allow a new device reset return to the default configuration led status meaning sagemcom broadband sas headquarters:...
