SAGEMCOM RCI88-1000 Quick Start Manual - Quick Start Guide
Quick Start Guide
First installation
Once the receiver is physically connected and
switched on for the first time, you need to go
through the setup procedure to get your cable
TV and Radio channels.
1.
Switch on your TV.
2.
If your TV set does not switch automatically
on receiver mode, select the appropriate A/V
channel (HDMI, SCART, ...).
3.
Insert your Smartcard card into the Smartcard
reader of the receiver:
• Pull the flap to access the reader slot.
• The chip must be facing downwards.
4.
The first installation screen should appear.
Language Settings
5.
Select your preferred language using the
up
or down
key on the remote control
and press OK
to confirm.
Cable Signal Check
6.
The receiver searches for the cable signal.
Please wait until the receiver successfully
detects it.
7.
If the detection fails, ensure that the antenna
cable is connected correctly.
Press OK
to resume the installation.
If the receiver still cannot find the cable signal,
please contact your customer support hotline.
QG 253499438 RCI88-320-1000 KDG_GB.book Page 7 Vendredi, 13. juillet 2012 3:55 15