Sakar TR-4 Quick Start Manual - page 3
M2?+H"B82%&+*
The removable top of the tripod allows one to thread their camera or
video camera into a safe and secure position. This will allow one to take
photos or to record video without having to worry about a blurry or
[PISaÅVITXZWL]K\
Also, if one desires to quickly remove the camera from the tripod, one
does not have to go through lengthy steps to do so. By loosening the
lever on the side of the head of the tripod, one can remove the camera
(while it is still attached to the removable piece) and take a quick snap
shot. One can then replace the camera and the removable piece to its
original position and continue using the tripod
!2/.$)7<%N+.$%>"?2$"%
The screw that attaches to the camera (which is located on the top of the
tripod) is the most important piece to the tripod.
When one decides to attach their camera to the tripod, the removable
top must be taken off of the tripod (see above) and then the camera must
be placed on the tripod.
In order to do this, one needs to insert the screw into the respectable
hole on the camera and then turned all the way to the right, or until it
gets tight. Once this is complete, the camera is secure and is ready to be
placed onto the tripod and used.
&.$7)7<%052%>"?2$"%3+$)O+70"88D
A screw on the head of the tripod allows one to rotate the head of the
tripod around the base of the tripod.
The photographer can rotate the head of the tripod (where the cam-
era is located) after loosening the screw on the top of the tripod. By
tightening this same screw, the head of the tripod will remain locked
into place.
L"/#%0+%F.?*%0+%"%!2/0)+7
L"/#%0+%F.?*%0+%"%!2/0)+7
L"/#%0+%F.?*%0+%"%!2/0)+7