Sakura SRT-30RA Installation Manual - page 4
Page 3 of 15
INSTALLATION OF THE UNIT
Location For Installation
Install the unit in such way that air distributed by the unit cannot be drawn in again (as in the case of
short circuit of discharge air). Allow sufficient space for maintenance around the unit.
Ensure that there are no obstructions of air flow into or out of the unit. Remove obstacles which blocks
air intake or discharge.
When two or more outdoor units are installed in a location, they must be positioned such that one unit
will not be taking the discharge air from another.
The location must be well ventilated, so that the unit can draw and distribute plenty of air.
A place capable of bearing the weight of the outdoor unit and isolating noise and vibration.
A place protected from direct sunlight. Otherwise use an awning for protection, if necessary.
A place where smooth drainage of rain water and water formed by defrosting is acceptable.
A place where the unit will not be buried in snow.
A place where air outlet port is not exposed to strong wind.
A place where the air discharge and operating sound level will not annoy the neighbors.
The location must not be susceptible to dust or oil mist.
Caution
If the condensing unit is operated in an atmosphere containing oils (including machine oils), salt
(coastal area), sulfide gas (near hot spring, oil refinery plant), such substances may lead to failure of
the unit.