Salamander 6 bay low profile wall mount cabinet 1 of 11 503-250 [5.17] tip hazard warning! Cabinet must be affixed to wall. For use to prevent tipping in compliance with capacity of cabinet specified. Use with heavier equipment may result in instability or detachment causing tip over resulting in de...
Salamander 6 bay low profile wall mount cabinet 2 of 11 503-250 [5.17] hardware e a b c f i id part # description a 300-485 1/4-20 x 1/2” button head socket screw b 300-465 1/4-20 x 3/4” head socket screw c 301-730 5/16 x 2.5” lag bolt d 301-745 hollow wall anchors e 300-565 drop in nut f 300-470 5/...
Salamander 6 bay low profile wall mount cabinet 3 of 11 503-250 [5.17] warnings important safety instructions read all instructions before using this furnishing warning! Failure to comply with these instructions may result in accident involving serious personal injury. Failing to follow these instru...
Salamander 6 bay low profile wall mount cabinet 4 of 11 503-250 [5.17] 1. Unify cabinets align the top and bottom thru holes located on the front and back vertical cabinet extrusions. Bolt together as shown with screw (n), washers (i) and lock nut (o). I n i o warning! This step requires two people..
Salamander 6 bay low profile wall mount cabinet 5 of 11 503-250 [5.17] 2. Install mounting brackets tip hazard warning! Cabinet must be affixed to wall. A loosely mount bracket (h) using screw (a), washer (i) and drop-in nut (e) to rear horizontal extrusion as shown. A h e i.
Salamander 6 bay low profile wall mount cabinet 6 of 11 503-250 [5.17] prior to fastening to wall, it is important to level the cabinet with the floor by verifying that feet are properly adjusted. Check and level length and depth of cabinet. Note: adjustments has been provided in the bracket to moun...
Salamander 6 bay low profile wall mount cabinet 7 of 11 503-250 [5.17] drill 1/2” diameter hole. Hold metal channel flat alongside plastic straps and slide channel through hole. Hold ends of straps between thumb and forefinger and pull toward you until channel rests flush behind wall. Slide plastic ...
Salamander 6 bay low profile wall mount cabinet 8 of 11 503-250 [5.17] wood: locate two framing studs using a stud finder device. Masonry: place brackets in desired location. Use a 3/16” [5mm] drill bit and drill holes 2.5” [64mm] deep. 4b. Install wall fasteners (alternate ) b c d insert wall ancho...
Salamander 6 bay low profile wall mount cabinet 9 of 11 503-250 [5.17] 5. Install brush seal use with baseboard molding, trim work or gaps in uneven wall surfaces. Brush seal holders should stay flush to surface so that only brush is showing. Cabinet side peel off tape and install from inside of cab...
Salamander 6 bay low profile wall mount cabinet 10 of 11 503-250 [5.17] 6. Install shelves a b insert into post channel and slide to desired height. Level shelf by adjusting shelf peg positions and tighten screw using hex key. Note: drop-in nut must make a 1/4 turn in post. Assemble loosely as shown...
Salamander 6 bay low profile wall mount cabinet 11 of 11 503-250 [5.17] adjustment tips 3u vertical rack remove loosen screws on both sides. Then tilt rack until the hook is free and lift up until the rack is free from bottom screw. Re-install slide the slotted ends of the rack over the bottom screw...
