Salamander SEM 800 PDS Instruction Manual - page 5
7. TECHNICAL SPECIFICATIONS
Wires colours correspondence
Phase 1
Brown
Phase 2
Black
Phase 3
Grey
Neutral
Blue
Earth
Yellow-Green
The equipotential connection marked by this symbol must be linked with the
equipotential conductive connection of your installation by means of a minimum con-
duction of a 2.5 mm² section.
8. NORMS AND LEGALS DISPOSALS
The device is conform to :
IEC/EN 60335-1
IEC/EN 60335-2-48
EN 55014-1 + 55014-2
EN 61000-3-2 + 61000-3-3
Humidity protection degrees IPX3, in conformity with the norm 60335-2-48 (2008)
9. ELIMINATION OF THE ELECTRIC AND ELECTRONIC WASTE
The device respects the directives:
2002/96/CE (DEEE) N°34270064800021
2002/95/CE (ROHS)
2066/95 CE
2004/108 CE
Model
SEM 800 PDS
Voltage
380-415 V 3 N ~
Current
6.5 A/Phase
Power
4500 W
Weight
57 kg
Nb element
3
Cooking surface
740x375 mm
Outside dimensions
800x590x590 mm
8
PDS commutator
Energy regulator
Control pilot light
On/off pilot light
Commutator
Plate detection system (PDS)
5. FUNCTIONING / MANIPULATION
a) Installation / assembly:
- Unpack carefully the device of its packaging.
- Place the salamander on a plane and heatproof surface.
- Never place the device near a wall or near a partition makes of combustible
materials even if it is very well isolated.
- A distance of minimum 50 cm with the partition or the wall is necessary.
- Remove the protective film from the top, the rear, the sides and the tray.
- Unlock the movable top by unscrewing the screw located on the back of the
machine thanks to a 10 pipe key.
- In case of connection directly to the electrical network, a disconnection mode
has to be planned in conformity with the norms.
CAUTION :
During use: never place the machine on surfaces or near walls, partitions or
kitchen furniture and similar— except if they are made with a non combustible
material or recovered with non combustible thermic insulation, and pay atten-
tion to fire preventions rules.
3
1
2
1
3
5
2
5
4
4
5
6
6