1. DL manuals
  2. Salamander
  3. Indoor Furnishing
  4. SN20
  5. Assembly Instruction

Salamander SN20 Assembly Instruction

Summary of SN20

  • Page 1

    Synergy twin unit - sn20 / sn30 / sn40 connector bolts top shelf aluminum posts shelf peg leveler foot hex nut washer heavy shelf bracket low head screw flat nut rubber tab bottom shelf warning: if you are installing accessories such as doors or drawers to the base unit, read all instructions for th...

  • Page 2: Parts

    Salamander designs ltd. 800-535-5659 • www.Salamanderdesigns.Com ©2002 salamander designs ltd. (300-470) washer (300-540) connector bolt (p-300-320) - leveler foot 6x 6x 6x (p-400-040) - level (400-060) - 3/16” hex key 1x 1x limited warranty for five full years salamander designs ltd will repair or ...

  • Page 3: Add Shelf Pegs

    1 b b a a leveler foot hex nut washer 90 o b . Connect post screw foot with metal washer through bottom shelf and onto the end of an extruded post. Hand tighten fully then use wrench on hex nut to tighten nut onto underside of shelf. A . Square post square the post to the bottom shelf. B . Gently ti...

  • Page 4: Attach Rear Panel

    Side panels before enclosing the unit with the top shelf install side panels (if applicable). See side panel instructions c . Fine tuning use the bubble level to precisely adjust the shelves. Be sure to level both side to side as well as front to back. Use the hex key to tighten each peg. A . Adjust...