1. DL manuals
  2. Salamander
  3. Indoor Furnishing
  4. SYNERGY 323
  5. Instructions

Salamander SYNERGY 323 Instructions

Summary of SYNERGY 323

  • Page 1

    Before you begin: • unpack all parts before beginning and refer to the drawing below. • shelf pegs and door hinges must slide into the channels of the post in the correct order. They cannot be removed individually without disassembling the whole unit. Synergy 323 twin instructions includes: (1) twin...

  • Page 2

    ! ! A b 1 leveler foot hex nut washer 90 o b . Connect post screw foot with metal washer through bottom shelf and onto the end of an extruded post. Hand tighten fully and use wrench on hex nut to tighten nut onto underside of shelf. A . Square post square the post to the bottom shelf. Connect posts ...

  • Page 3: Attach Door

    A . Attach hinges to door frames insert the hinges into the corresponding holes on the doors. Turn the screws 1/4 turn to the right to lock hinges in place. Note: do not over tighten or the hinge will break. D . Door pull screw the door pull into place. B . Adjust clearance doors should be 1/8” abov...

  • Page 4: Attach Rear Panel

    A . Insert hardware combine the 1” threaded studs with the flat nuts. Slide hardware into rear channel. C . Secure studs use the hex key to secure the all studs to the posts. B . Place panel allow bottom studs to remain loose at bottom of post. Align the spacer tool at the top of the post, then posi...