Saleen VI Series Maintenance Schedule

Manual is about: SUPERCHARGER FOR 2005-07 MUSTANG

Summary of VI Series

  • Page 1

    Saleen series vi supercharger for 2005-07 mustang maintenance schedule very little maintenance is required for your series vi supercharger. There are two key fluids involved in the kit which you should pay attention to. Please hold on to the installation manual for the supercharger kit to aid in the...

  • Page 2

    Communication with a saleen-calibrated pcm (powertrain control module) • the pcm in each saleen vehicle is programmed with specific performance and calibration data. • saleen-programmed pcms have a unique “pcm id” number. This number can be found on the saleen label affixed to the pcm or it can be l...

  • Page 3

    Rotor clash on twin-screw supercharger the saleen series iv and series vi superchargers are extremely efficient twin-screw style superchargers. They are chosen for their excellent power delivery characteristics, and for their ability to keep air temperature cool and maintain high boost under harsh o...

  • Page 4

    Service for warranty remove only the complete manifold assembly as shown below for warranty returns and repairs. Fuel rails and injectors need not be completed. Never disassemble any part of the core supercharger unit as this will void any explicit or implied warranty. Check supercharger oil level h...

  • Page 5

    Check supercharger oil level here figure 1 1. Belt routing diagram, 2005-07 s281 sc. (figure 1) 2. S331 sc belt routing, figure 2. 3. Tamper-proof pulley seal; do not remove under any circumstance!.

  • Page 6

    Figure 2 1. The coolant for the supercharger’s intercooler system should reach the bottom of the neck for the recovery tank. S281 recovery tank (figure xx) s331 recovery tank (figure xy) 2. The water pump on the s281 will operate with the key in the accessory position (position ii). With the key in ...

  • Page 7

    115.Remove the pressure test tool, and refill the recovery tank to the cold fill range with the 50/50 water/anti- freeze mix. (figure 98) 116.Install the radiator recovery tank cap. 117.Cap off the inlet to the intercooler recovery tank using a short piece of ¾” hose that is plugged at one end. (fig...

  • Page 8

    Figure 100 figure 101 123.Remove pressure tool from the tank and fill tank with an 80/20 water/anti- freeze mix, to 1” from the top. 124.Install the intercooler tank cap 00- 2001-c09994* onto the tank. (topmost arrow in figure 104) 125.Attach the water pump timer 178-372 to the inside of the passeng...

  • Page 9

    Figure 104 w.P. Timer figure 105.