Salora ELITE 1 Instruction Manual - page 5

7

 POWER SUPPLY

Mains operation

Check if the mains voltage on the type plate (on the bottom of the device) corresponds to your local 

mains supply. If not, consult your dealer or service organization.

1.  Insert the power cord into the 

AC Input socket on the side of the device.

2.  Plug the mains plug into the mains socket.

Caution: 

In order to disconnect the device from the mains completely, the mains plug should be removed from the 

mains socket completely.

Battery operation (Remote Control)

1.  Open the battery compartment at the back of the remote control by pulling out the cover..

2.  Insert two batteries (2 x 1.5V, Type R03 / UM4 / AAA size) with the correct polarity as shown in the  

battery compartment. 

3.  Replace the cover.

4.  If the remote is not to be used for any extended period of time, it is recommended that the batteries  

are removed.

Caution: 

Do not expose the batteries to excessive heat such as sunshine, fire or the like. 

Remove the batteries from the device when they will not be used for a long period of time.

Notes:

Batteries should not be disposed of by incineration and with household waste. Disposable batteries 

should be taken to a suitable recycling centre if possible.

8

GENERAL FUNCTIONS

Switching the device on and off

1.  Press the 

On/Off button to switch on the device from standby mode. The last function used is 

automatically selected.

2.  Switch the device to standby by pressing the 

On/Off button. The display shows ”GOOD BYE”

Adjusting the brightness of the display

1.  Press the 

Dimmer button to adjust the brightness of display backlight in three levels (bright, 

medium, or off).

2.  The auto dimmer function automatically adjusts the intensity of display backlight to suit the 

brightness of the surroundings.

Notes: 

Minimum power consumption in standby mode is only achieved if the display backlight is switched off.

Changing the color of display

1.  Repeatedly press the 

Color button to change the color of display backlight. There are 8 colors for  

 selection.

Selecting the function mode

1.  Repeatedly press the 

Function button to select the function between FM Tuner, MW Tuner, CD, SD  

and Auxiliary input modes. 

Adjusting the volume

1.  Adjusts the volume by pressing the 

Volume− or Volume+ button.

Muting

1.  Pressing the 

Mute button to switch the sound on and off. The display shows “Mute”.

Switching the Ultra Bass System on and off

This function boosts the bass frequencies.

1.  Press and hold the 

DSC/UBS button to switch the Ultra Bass System on and off. The display shows  

the symbol 

 when UBS is switched on. 

Notes: 

Listening with UBS at high volume may have distortion. Recommend to use at low volume.

Selecting the sound effects

You can select the sound settings USER, CLASSIC, POP, JAZZ and ROCK. The default setting is USER.

1.  Repeatedly press the 

DSC/UBS button to select the desired sound setting. Symbol is shown on the  

display to indicate your setting.