Salt Dogg SHPE2000 Installation instructions manual

1

9049 Tyler Blvd. • Mentor, Ohio 44060

Phone (440) 974-8888 • Fax (440) 974-0165

Toll-Free Fax 800-841-8003 • saltdogg.com

Installation Instructions

—continued inside

SHPE2000, SHPE2000RED, SHPE2000YEL 

Series SaltDogg

®

 Electric Drive Poly Hopper 

Spreader

2.0 cubic yards

U.S. PATENT 9,562,333

Table of Contents 

General Information .....................................................................1

Safety Precautions .......................................................................1

Warranty Information ...................................................................2

Installation Instructions ............................................................ 2-4

Spreader Operation .....................................................................5

Spreader Maintenance .................................................................5

Repair Parts & Drawings .........................................................6-10

General Information 

Spreader models:

  • SHPE2000- spreader with standard length chute

  • SHPE2000X- spreader with extended length chute

Overall Length:

 96 inches 

Overall Width:

 47-1/2 inches 

Overall Height: 

(installed): 40 inches

Empty Weight:

 437 lbs. (standard chute), 441 lbs. (extended chute)

Capacity Struck: 

2.0 cu. yd. 

Average Installation Time: 

3 hrs.

Vehicle Requirements 

• 3/4 or 1 ton pick-up truck above 8500# GVWR. 

• 135 AMP or higher alternator is recommended. 

Materials Recommended to Spread

SHPE2000 SALT DOGG SPREADER WARRANTY 

INFORMATION

This warranty replaces all previous warranties and no 

employee of this company is authorized to extend addi-

tional warranties, or agreements, or implications 

not explicitly covered herein. 

Buyers Products Company warrants all parts of the 

product to be free from defects in material and workman-

ship for a period of two (2) years. Parts must be properly 

installed and used under normal conditions. Normal wear 

is excluded.

Any part, which has been altered, including modifica-

tions, misuse, accident, or lack of maintenance will not 

be considered under this warranty.

The sole responsibility of Buyers Products Company 

under this warranty is limited to repairing or replacing any 

part(s), which are returned, prepaid, 30 

days after such defect is discovered, and returned part(s) 

are found to be defective by Buyers Products Company. 

Authorization from Buyers Products Company must be 

obtained before returning any part. The following infor-

mation must accompany defective parts returned 

to Buyers Products Company: RMA #, spreader model, 

serial number, date installed, and distributor from whom 

purchased.

Buyers Products Company shall not be liable for damage 

arising out of failure of any unit to operate properly, or 

failure, or delay in work, or for any consequential dam-

ages. No charges for transportation or labor performed 

on any part will be allowed under this warranty.

CAUTION

Do not overload vehicle beyond the vehicle’s GVWR or GAWR. 

Check vehicle's load rating certification sticker for maximum 

vehicle capacity.

Average Material Weights

Materials to use  

Weight (pounds per cubic yard)

Fine Salt-Dry  

2,250

Coarse Salt-Dry  

1,431

Sand/Salt up to 50/50 Mix-Dry 

2,700

Note:

 To calculate the total spreader weight (including ice 

control material), add the empty spreader weight plus the ice 

control material and spreader accessories.