Salt Dogg TGS03 Installation Instructions Manual

1

9049 Tyler Blvd. • Mentor, Ohio 44060

Phone (440) 974-8888 • Fax (440) 974-0165

Toll-Free Fax 800-841-8003 • saltdogg.com

Installation Instructions

TGS03  Salt Spreader

TGS03RED  Salt Spreader

TGS03YEL  Salt Spreader

—continued inside

WARNING

Observe the following Safety Precautions before,  

during and after operating this spreader. By following 

these precautions and common sense, possible injury  

to persons and potential damage to this machine may be 

avoided.

SPREADER WARRANTY

This warranty replaces all previous warranties and 

no employee of this company is authorized to extend 

additional warranties, or agreements, or implications 

not explicitly covered herein.

Buyers Products Company warrants all parts of 

the product to be free from defects in material and 

workmanship for a period of one (1) year. Parts must be 

properly installed and used under normal conditions. 

Normal wear is excluded.

Any part, which has been altered, including 

modifications, misuse, accident, or lack of maintenance 

will not be considered under this warranty. 

The sole responsibility of Buyers Products Company 

under this warranty is limited to repairing or replacing 

any part(s), which are returned, prepaid, 30 days after 

such defect is discovered, and returned part(s) are 

found to be defective by Buyers Products Company.

Authorization from Buyers Products Company must 

be obtained before returning any part. The following 

information must accompany defective parts returned 

to Buyers Products Company: RMA #, spreader model, 

serial number, date installed, and distributor from 

whom purchased.

Buyers Products Company shall not be liable for 

damage arising out of failure of any unit to operate 

properly, or failure, or delay in work, or for any 

consequential damages. No charges for transportation 

or labor performed on any part will be allowed under 

this warranty.

Safety Precautions

1. Read this entire Installation Instruction before 

operating this spreader. 

2. Read all safety decals on the spreader before 

operating. 

3. Verify that all personnel are clear of the  

spreader spray area before starting or operating this 

spreader. 

4. Do not adjust, clean, lubricate or unclog material 

jams without first turning off the spreader. 

5. Make sure the spreader is securely fastened to 

the vehicle in accordance with this manual. 

6. Do not operate a spreader that is in need of main-

tenance or repairs. 

7. Always disconnect the battery before removing or 

replacing electrical components. 

Spreader Assembly

Check contents of box against parts list to make 

sure all components are included. When ordering 

replacement or spare parts refer to parts list for part 

numbers.