Salt Dogg WB400 Assembly Instructions

TM

1

Assembly Instructions

9049 Tyler Blvd. • Mentor, Ohio 44060

Phone (440) 974-8888 • Fax (440) 974-0165

Toll-Free Fax 800-841-8003 • saltdogg.com

WB400 

Walk Behind Drop Salt Spreader

Check contents of box against the parts list to 

make sure all components are included. When 

ordering replacement or spare parts refer to the 

parts list for part numbers.

Tools Needed For Assembly

• (2) 7/16 Wrenches

• (2) 1/2 Wrenches

• (1) 5/32 Allen key

Assembly

Attaching the supports, and Hopper. (see fig. 1)

1. Remove contents from box and place the 

preassembled portion of the spreader upright on its 

wheels

2. Assemble left hand support arm (3016744) & line 

up the holes, fasten with (3) 3/8-16 bolts, washers, 

lock washers, and nylock nuts. Threads of bolts 

should face away from wheels. Tighten fasteners. 

3. Assemble left hand support arm (3016745) & line 

up the holes, fasten with (3) 3/8-16 bolts, washers, 

lock washers, and nylock nuts. Threads of bolts 

should face away from wheel. Tighten fasteners. 

Attaching the Linkage Rod (see fig. 2)

1. Insert the 90 degree end of the linkage rod in 

the holes located in the lower middle of the hopper 

frame. The rod will remain loose until the handles 

are attached.

HOPPER ASSEMBLY

3016745

RH SUPPORT

3 BOLTS

PER SIDE

3016744

LH SUPPORT

Fig. 1

ROD (3016748)

INSERT INTO HOLES AS SHOWN

Fig. 2