Salter Brecknell 402 User Manual - page 6
CURRENCY CHANGE INSTRUCTION AND INFORMATION
The Salter Brecknell 402 currency information is contained in an EPROM module. This is a
pre-programmed memory device that is mounted on a plug in the printed circuit board. In the
event of a coin change, contact the Salter Brecknell Sales Department at the address
below for information regarding new EPROM modules.
The EPROM rate chip is positioned on the underside of the coin scale. Remove the lid by
pushing the catch and pulling upwards.
The EPROM is situated directly beneath the lid. To remove, gently ease the chip from socket.
When inserting a new chip, ensure that the replacement is installed the correct way into the
socket. Insert the chip into place by pushing down gently. Replace the compartment lid and
your coin scale will be ready for use.
Salter Brecknell Weighing Products
1000 Armstrong Drive
Fairmont, Minnesota 56031
Toll Free 800-637-0529 · Voice 507-238-8702 · Fax 507-238-8271
Email:
sales@salterbrecknell.com
www.salterbrecknell.com
September 2003
©Copyright 2001, 2002 Salter Brecknell Weighing Products
Pull EPROM gently
upwards to remove
chip from sockets.
Push catch and
lift compartment
lid