Salton Elite SPF50E Instructions Manual - page 4
4
ASSEMBLY OF THE BASE SECTION
1. Attach the weight to the bottom of the stand using 4
screws.
2. Attach the column to the stand with 4 screws
3. Unscrew and take off the height adjustment screw
4. Slide the stand cover down the column to rest on the
stand.
5. Pull up the height extension tube and refit the height
adjustment screw. Tighten the height adjustment screw
before assembling the top section of the fan.
6. Fit the motor section to the height extension tube and
tighten the thumbscrew. Ensure that the thumbscrew is fully tightened before
operating the unit. Tighten the tilt adjustment knob.
7. Remove the fibre glass sleeve from the shaft, and unscrew the rear guard retaining
nut by turning it counter-clockwise. Discard the fibre glass sleeve.
8. Set the rear guard grill onto the shaft with the handle uppermost and screw on the
guard retaining nut in a clockwise direction until tight.
9. Place the blade onto the shaft and screw on the blade retaining nut in a counter-
clockwise direction until tight.
10. Open the clips on the front guard grill and place the front and rear guard grills
together. Align the locking screw holes and tighten the locking screw and nut.
11. Secure both guard grills firmly by fitting and tightening the locking screw and nut.