Salton Elite STI 01E Instructions For The Use And Care - page 7
7
BURST OF STEAM IRONING
1.
By pushing the burst of steam button, a powerful “shot” of steam is released from the soleplate.
This can be very useful for removing stubborn creases.
2.
The “Burst-Of-Steam” function can only be used when ironing at high temperatures (i.e. positions
ranging from “● ●” to “● ● ●”) and at an interval of 5 seconds.
VERTICAL STEAM IRONING
“Burst-Of-Steam” can also be applied when holding the iron in a vertical position, which is useful for
removing creases from hanging clothes or curtains etc. This function can be used only at higher ironing
temperatures and at an interval of 5 seconds.
Important:
This iron is not suitable for continuous vertical steaming although burst of steam can be
used regularly.
1. Fill water into the iron as described above to the maximum mark.
2. Stand the iron on its station.
3. Connect the iron to a suitable mains supply outlet.
4. Turn the temperature control dial to the MAX setting and allow the iron time to heat up to the set
temperature.
5. The pilot light will turn off when the required temperature is reached. The iron is ready for use.
6. Press the Bursting button once.
7. Steam will penetrate into the garment removing wrinkles.
8. Wait a few seconds before pressing the Bursting Button again. Usually 3 bursts of steam will be
sufficient to remove stubborn wrinkles.
NOTE: With conventional steam ironing, water may leak from the soleplate if a too low temperature has
been selected. If this happens, turn the temperature control dial to the advised position; steaming will
recommence as soon as the appropriate, temperature has been reached.
DRY IRONING
1. Turn the temperature control dial to MIN position and insert the power cord into the wall socket.
2. According to the Temperature Control Settings and Garment Care Instructions, turn the temperature
control dial to the correct temperature. When the pilot light turns off, the required temperature is
reached. The iron is ready for use.
3. Do not use the Steam Trigger Button during dry ironing.
4. After ironing, please turn the Temperature Control Dial to the MIN position. Pull out the plug, stand
the iron on the station, and wait until the soleplate has cooled down completely before packing
away for storage.