Salton FC1438 Instruction Booklet - How To Use
HOW TO USE
1. Ensure that the unit is unplugged from the wall outlet.
2. Open the Cover of the Water Reservoir and fill with fresh cold water up to
the MAX level mark indicated inside the water reservoir.
3. Place the Travel Mug under the Dispenser. The Travel Mug Cover can be
taken off or left on. IMPORTANT: If the cover is left on, be sure that
the sipping hole is open so coffee can flow into the Travel Mug.
4. Plug the unit into a 120 Volt A.C. wall outlet.
5. If the Indicator Light is already on then the coffee maker will start
automatically. If the Indicator Light is not on, press the "START" button
and the light will illuminate and the coffee maker will start.
6. When the coffee has finished brewing, the indicator light will go out.
Unplug from the wall outlet.
NOTE: Wait 30 seconds before brewing another cup of coffee.
CAUTION: Be very careful when opening the Water Reservoir Cover after
brewing as this area is hot and steamy.
IMPORTANT: Once the START button is pushed, it cannot be turned off. The unit
must run its cycle. Wait for the Indicator Light to go off, then unplug from the
wall outlet.
NOTE: The START button has an internal memory. Once the indicator Light goes
off and the unit is unplugged from the wall outlet, be careful not to push the
START button, otherwise the next time the unit is plugged, the Indicator Light
will be illuminated and the brewing cycle will begin.
4
Booklet_FC1438_Salton Booklet 8/13/14 12:00 AM Page 4