Salton MEPE123BT Owner's Manual - Filtering Water
Filtering Water
The quality of water you use directly affects the taste of your coffee.
The better the water, the better the coffee.
With 123 Spresso you can
use household tap water or spring water.
Never use carbonated
water.
We’ve included a “universal” Water Filter Holder. The Holder accepts
commonly available cylinder-type filters, allowing you to use the brand
of your personal preference.
To use the Filter Holder, place it on top of the empty water tank. It fits
comfortably into the top of the tank. Add your filter.
Always
follow the
filter manufacturer’s directions for use, especially when using a
fresh filter.
When you have prepared the filter and placed it into the Holder on the
Water Tank Lid, you may add water.
Again, follow the filter manufacturer’s directions.
Make sure that
water has actually flowed into the tank before you start brewing.
Filter flow rates vary from brand to brand, so always check first.
Brewing
Espresso
1.
Plug the machine into a 120V ~
60 Hz outlet.
2.
Before brewing espresso, make
sure the Water Tank is filled with
fresh water.
3.
Replace the Water Tank to its
original position, making sure it is
properly seated on the machine.
4.
Close the Lid on the top of the
Water Tank.
5.
Place a heat resistant cup under
the Coffee Spout, on top of the Cup Rest Grill.
6.
Switch the machine to the “ON” position to heat and press the
Temperature Switch to the “COFFEE CUP”.
7
7.
After a couple of minutes
the Green “GO” Light
illuminates. Turn the
Function Selector (on
the side) to the
“COFFEE CUP”. This
starts the water flowing.
6
Before First Use
(continued)
Green
“GO”
Light
Function
Selector
COFFEE
position
Function
Selector
NEUTRAL
position
• Let approximately 2 ounces of hot water drain into the heat proof
container you placed on the Cup Rest Grill. There will be some
run-off water in the Water Overflow Tray. This is normal.
• Then turn the Function Selector back to the “NEUTRAL” position.
CAUTION: YOU MUST STOP THE WATER FLOW BY TURNING
THE FUNCTION SELECTOR TO “NEUTRAL.” THE WATER
FLOW DOES NOT STOP AUTOMATICALLY.
8.
When the water stops flowing from the coffee spout, carefully
dispose of hot water in the cup and the Water Overflow Tray. Your
123 Spresso is now ready to use.
•
•