Salton SB900E Instructions And Warranty Information - page 3
3
13. Do not let the cord hang over the edge of a table or counter. Ensure that the cord
is not in a position where it can be pulled on inadvertently.
14. Do not allow the cord to touch hot surfaces and do not place on or near a hot gas
or electric burner or in a heated oven.
15. Do not use the appliance on a gas or electric cooking top or over or near an open
flame.
16. Use of an extension cord with this appliance is not recommended. However, if it
is necessary to use an extension lead, ensure that the lead is suited to the power
consumption of the appliance to avoid overheating of the extension cord,
appliance or plug point. Do not place the extension cord in a position where it can
be pulled on by children or animals or tripped over.
17. This appliance is not suitable for outdoor use. Do not use this appliance for
anything other than its intended use.
18. Never carry the appliance using the power cord.
19. Do not leave this appliance unattended during use. Always unplug when the
blender is not in use or before cleaning.
20. Always operate the appliance on a smooth, even, stable surface. Always ensure
that the lid is in place before operating appliance.
21. Turn the blender on only after the blending unit has been assembled correctly
and has been inserted into the motor block and the lid has been attached.
Always wait until the blender has stopped completely before removing the
blending unit from the motor block.
22. Keep hands and other utensils out of the blender while the blender is in use, to
reduce the risk of severe injury to persons or damage to the machine.
23. Ensure that the rotary
switch is in the “O” position after each use.
24. When blending hot liquids, allow them to cool to lukewarm before pouring them
into the blending jug. Remove the inner cover while blending warm liquids.
25. Do not operate the appliance without food or liquid in the jug.
26. To avoid the danger of fire and/or explosion, do not use this blender to stir paints
or solvents.
27. The manufacturer does not accept responsibility for any damage or injury caused
by improper or incorrect use, or for repairs carried out by unauthorised
personnel.