Salton SBH46 Instructions And Warranty - page 5
5
TO INSTALL THE HEATER
Remove the screw marked A and the
screw corresponding on the bottom of the
wall mounting bracket.
Remove the panel marked B.
Mark where the four holes are to be drilled
to mount the unit using the bracket as a
guide.
Drill four 6mm holes and insert the wall
plugs.
Mount the heater over the holes, using the four screws to secure it to the wall. Rotate
the heater on the bracket to give access to all four holes. Ensure the screws are
tightened sufficiently.
Place the panel marked B back in place and replace the two screws marked A.
Ensure all the screws are tightened.
Connect the heater to a source of power using the colour guideline provided in
INSTALLATION GUIDELINES.
OPERATING INSTRUCTIONS
Switch on the heater using the cord only.
Pull the cord once for one bar to heat, and pull the cord again for two bars to heat. At
each pull, the number in the viewing window will change, indicating the number of
bars turned on. To turn off the heater, pull the cord a third time, so that the
“O” shows
in the viewing window. The heater is now Off.
Do not leave this heater unattended once switched on.
This heater gets hot when switched on. Do not touch the heater when switched on.
To change the angle of the heat radiance, turn the screws on either side of the
bracket once in an anti-clockwise direction. Change the angle of the heater as
desired, and tighten the screws by turning in a clockwise direction. Do not change
the angle of the heater with the screws still tight, as this may cause permanent
damage to the heater.
A
B