Salus KL08RF Installation And Wiring Manual
KL08RF
Installation and Wiring Guide
www.salus-controls.com Technical Helpline +44 (0) 1226 323 961
GROUP 2
GROUP CONTROL
THERMOSTAT
MAINS POWERED
(MODEL VS10WRF)
BATTERY POWERED
PROGRAMMABLE
ROOM THERMOSTAT
(MODEL VS20WRF)
GROUP 1
THERMOSTAT
(VS20WRF)
GROUP 1
THERMOSTAT
(VS20WRF)
GROUP 1
THERMOSTAT
(VS10WRF)
GROUP 2
THERMOSTAT
(VS10WRF)
GROUP 2 CONTROL
THERMOSTAT
(VS20WRF)
GROUP 1
STANDALONE
PROGRAMMABLE
ROOM THERMOSTAT
(MODEL VS10W
(MODEL VS20WRF)
WRF)
WRF)
SUPPLIED CABLES
230V TO UFH PUMP
UNDERFLOOR HEATING MANIFOLD
1.5MM
2
CABLE (INSTALLER SUPPLIED)
Optional boiler connection
N
L
External power supply
N
L
These instructions apply to the SALUS model stated above.
Warning
This product must be fitted by a competent person, and
installation must comply with the guidance, standards and
regulations applicable to the country or state where the
product is installed. Failure to comply with the requirements
of the relevant guidance, standards and regulations could lead
to injury, death or prosecution.
Warning
Always isolate the AC mains supply before installing or working
on any components that require 230 V AC 50Hz supply.
For PDF Installation guide go to www.salus-controls.com
Meets the following EC Directives
• Electro-Magntic Compatibility directive 2004 / 108 / EC
• Low-voltage Directive 2006/95/EC
Optional wireless
receiver RX10RF
Maintaining a policy of continued product development SALUS Controls plc reserves the right to change
specification, design and materials of products listed on this installation guide without prior notice.
Issue Date: October 2014 Document Number 00106
Warning
The earth terminals on the KL08RF are for earth parking only.
These terminals provide no earth protection.
iT600 Wiring Centre KL08RF 028 V9.qxp_Layout 1 04.12.2014 12:30 Strona 1