Salus Sports S-Belt Bike User Manual - Assembly Instructions
5
7 easy steps to assemble then you’re ready to workout – it takes approx 30 mins to assemble.
ASSEMBLY INSTRUCTIONS
Step 1
Step 2
Attach the front (17) and back (19)
stabilizers to the main frame (25) with
the domed nuts, washers (12 and
20) and key-head bolts (21 and 18)
provided.
Tip: Ensure the warning label is
facing you before attaching the back
stabilizer.
Inside the main frame, you will see a red
plastic rectangle. Pull it towards you to
loosen it from its current position.
Tip: This will make it easier for you to do
the next step.
Take the front support pole (5) and
connect the upper (8) and lower (10)
sensor wires (see insert).
Turn the tension control (30) to the left
until it stops.
Hook the tension control wire (26) into
the red plastic (32) inside the main frame
(25). To do this you must pull the tension
control wire (26) to full length by pulling
upwards on the front support pole (5).
Tip: for better leverage do this whilst
standing.
Fix the 4 sets of fixing bolts (11) and
washers (12) provided to the front
support pole (5).
Tip: Tape the tension wire onto the
support pole so it doesn’t fall inside.
26
8
26
32
30
10