Salutron ComBi D3 User Manual - page 2
Automatic detection for the measurement
on
ferro or non-ferro
The automatic detection of subsurface
material (Fe - ferro or NFe - non-ferro) is
indicated by the AUTO icon in the display.
Before each measurement, the device
checks the material and selects the
corresponds measurement method.
If the device is placed on magnetic material
(ferro),
Fe
icon is indicated in the display. By
measurements on non magnetic metals (non
ferro),
nFe
icon is indicated in the display.
The GAG option of the menu enables or
disables the automatic detection.
Display of the average value (mean) and the
number of measurements
The device calculates with each measurement
and without storing of individual results the
average value. The display of mean is due to
the short press (less than 3 seconds) of the
ON/OFF-button and is indicated with
Ave
(average) icon in the display. If the ON/OFF-
button is short pressed again, the number of
last measurements applied to the mean
together with
n
icon appears in the display. The
rST option of the menu resets these values.
Delivery
➢
Coating thickness gauge ComBi-D3
➢
Carrying case with two zero plates (steel
and aluminum)
➢
9 Volt battery (alkaline)
➢
user manual
Technical Specifications
Base material (substrate)
steel or iron:
Non magnetic metals:
such zinc, copper, brass,
aluminum, stainless steel,
anodized aluminum:
Continuous measuring range:
Display of measured values:
Display resolution:
Repeatability (basic tolerance):
Minimum object size:
Minimum curvature:
convex:
concave:
Minimum substrate thickness:
Fe:
NFe:
Temperature range:
Storing:
Operating:
Probes:
Power supply:
Dimension (LxWxH):
Weight incl. battery:
n
Fe
NFe
0 - 3.500 µm or 0 -140 mil
from 0.0 - 999 in µm
from 1.00 - 3.50 in mm
or from 0.00 - 140 mil
0,1 µm in the range of 0.0 - 99.9 µm
1 µm
in the range of 100 - 999 µm
0.01 mm in the range of 1.00 - 3.50 mm
or
0.01 mil in the range of 0.00 - 9.99 mil
0.1 mil in the range of 10.0 - 99.9 mil
1.0 mil in the range of 100 - 140 mil
+/- (1,5 µm + 2%)
from 0 - 1000 µm
+/- 3,5%
from 1.00 - 3.50 mm
10 x 10 mm² or (0.4“ x 0.4“)
5 mm or 0.02“
30 mm or 1“
0.20 mm or 8 mil
0.05 mm or 2 mil
-10°C to +60°C
(14°F to 140°F)
0°C to +60°C
(32°F to 140°F)
Single point
9 Volt E block alkaline
118 x 58 x 38 mm or 4.6" x 2.3" x 1.5"
approx. 150 g or 5.3 oz
The ComBi-D3 corresponds national (DIN) and
international (ISO, BS, ASTM) standards and have the
CE mark.
DIN 50981, 50984
ISO 2178, 2360, 2808
BS 5411 (3, 11) 3900 (c, 5)
ASTM B499, D1400
Technical data subject to change without notification.
Stand: 05/2016