Samlexpower ADJ-28 Owner's Manual - Section 3  |

8  |  SAMLEX AMERICA INC.    

SECTION 3  |  

Installation

10.  Fig. 9 corresponds to one possible tilt-angle. Other tilt-angles maybe possible by 

using different hole combinations.

Travelling mode

11.  The mounting hardware should be connected in the tilted position only when the 

RV is stationary. When the RV is in motion, the mounting hardware should be in 

the flat mount position. 

12.  In order to do this remove the ¼”-20 x 1" carriage bolt carriage bolts by loosening 

the ¼” wing nuts at points B and C (Fig. 9).

13.  Lower the 28” mounting rails and the 14” brackets so that the square holes of 

each set of the mounting rails and brackets align with each other and the solar 

panel is flat (Fig. 10).

14.  Using the ¼”- 20 x 1" carriage bolts and the ¼” wing nuts, secure the structure in 

this position (Fig. 10).

Fig. 10 Travelling Mode

Point C

Point A

Point B

Solar Panel

28” Mounting Rail

28” Mounting Rail

RV Roof

SAMLEX AMERICA BATTERY

CAR BATTERIES