1. DL manuals
  2. Samlexpower
  3. Inverter
  4. SA-2000K Series
  5. User Manual

Samlexpower SA-2000K Series User Manual

Manual is about: SA-2000K Series

Summary of SA-2000K Series

  • Page 1

    Sa-2000k series pure sine wave inverter user’s manual www.Samlexpower.Com.

  • Page 2: Table of Contents

    Www.Samlexpower.Com table of contents 1. Important safety information.……………………………………………… 1 1-1 general safety precautions…………………………………………… 1 1-2 battery precautions………………………..………………………….. 1 2. Features………………………………………………………………………... 2 2-1 application………………………………………………………………. 2 2-2 electrical performa...

  • Page 3: Warning!

    Www.Samlexpower.Com 1. Important safety instructions warning! Before using the inverter, read and save the safety instructions. 1 1-1. General safety precautions 1-1-1. Do not expose the inverter to rain, snow, spray, bilge or dust. To reduce risk of hazard, do not cover or obstruct the ventilation ...

  • Page 4: 2. Features

    Www.Samlexpower.Com 2. Features pure sine wave output (thd output frequency：50 / 60hz switch selectable input & output fully isolated power saving mode to conserve energy high efficiency 89~94% can drive highly reactive & capacitive loads at start up tri-color indicators show input voltage & output ...

  • Page 5

    2-2. Electrical performance specification model no. Item sa-2000k-112 sa-2000k-124 continuous output power 2000w maximum output power 2200w surge rating (max) 4000w input voltage 12v 24v output voltage 100 / 110 / 120v +/- 5% frequency (switch selectable) 50 / 60hz +/- 0.05% output waveform pure sin...

  • Page 6: 2-3. Mechanical Drawings

    Www.Samlexpower.Com 2-3. Mechanical drawings 245.00 [9. 65] sa- 200 0k 3 68. 00 [14.49 ] pure sine wave power invert er 16 5.2 5 [6 .51 ] 209.00 [8.23] ac output pure sine wave inverter s4 freq. S2 s1 s3 pwr. Sav. O i 0 remo. Load level status input level off on i 177.00 [6.97] 200 0 w 3000 w 4.

  • Page 7: 3. Introduction

    Www.Samlexpower.Com 3. Introduction this power inverter series is one of the most advanced line of mobile ac power systems. To get the most effective power inverter, it must be installed and used properly. Please read the instructions of this manual before you install and operate this model. 3-1. Fr...

  • Page 8

    Www.Samlexpower.Com 3-1-3. Input level：displays input voltages led status dc 12v dc 24v red slow blink 10.3~10.6 20.5~21.2 red 10.6~11.0 21.2~21.8 orange 11.0~12.1 21.8~24.1 green 12.1~14.2 24.1~28.6 orange blink 14.2~15.0 28.6~30.0 over red blink 15.0 30.0 3-1-4. Load level：displays ac loads (watts...

  • Page 9

    Www.Samlexpower.Com 3-1-7. Power saving mode: power saving mode is adjustable and set by the dip switches, s1, s2 and s3 on the front panel. Example: with the watt setting at 15w, a 15w↑ load will make the inverter operate normally, a 15w↓ load will enter into the power saving mode. Sa-2000k s1 s2 s...

  • Page 10

    Www.Samlexpower.Com 3-1-8. Ac outlets north american ground fault circuit interrupter (gfci) with duplex nema5-20 receptacles is provided as a standard supply. Other types have to be ordered specifically. Australia / new zealand iec-2 universal hard wire united kingdom iec-1 north american ground fa...

  • Page 11

    Www.Samlexpower.Com 3-2. Rear panel operations 3-2-1. Remote port the sa series inverter is compatible with any of the following optional remote controls: • s-r8 – is common for 12v, 24 v input inverters • s-r6-12 – is meant for the 12v input inverters • s-r6-24 – is meant for the 24v input inverter...

  • Page 12: Warning!

    Www.Samlexpower.Com connect dc input terminal to 12v / 24v battery or the other power sources. 【＋】 represents positive, and【－】represents negative. Reverse polarity connection will blow the internal fuse and may damage the inverter permanently. Model dc input voltage minimum maximum 12 v 10.5 15.0 24...

  • Page 13: 3.4. Installation

    Www.Samlexpower.Com 3.4. Installation the power inverter should be installed in an environment that meets the following requirements 3-4-1. Dry – do not allow water to drip on or enter into the inverter. 3-4-2. Cool – ambient air temperature should be between 0℃ and 40℃, the cooler the better. 3-4-3...

  • Page 14: 3-5. Dc Wiring Connections

    Www.Samlexpower.Com 3-5. Dc wiring connections follow this procedure to connect the battery cables to the dc input terminals of the inverter. The cables should be as short as possible (less than 10 feet / 3 meters ideally) and large enough to handle the required current in accordance with the electr...

  • Page 15: Warning!

    Www.Samlexpower.Com warning! The installation of a fuse must be on a positive cable. Failure to place a fuse on “+” cables running between the inverter and battery may cause damage to the inverter and will void warranty. Also, use only high quality copper wire and keep cable length short, a maximum ...

  • Page 16

    Www.Samlexpower.Com 14 sa-2000k inline fuse reverse polarity will damage unit shock hazard. Do not open. No user serviceable parts inside. Warning: dc input pos(+) chassis ground neg(-) remote port battery to inverter cable connection do not place anything between battery cable lug and terminal surf...

  • Page 17: 3-6. Ac Safety Grounding

    Www.Samlexpower.Com 3-6. Ac safety grounding the ac output ground wire should go to the grounding point for your loads (for example, a distribution panel ground bus). 3-6-1. Neutral grounding (gfci’s): 3-6-1-1. 120v models: the neutral conductor of the ac output circuit of the inverter is automatica...

  • Page 18: 3-7. Inverter Operation

    Www.Samlexpower.Com 3-7. Inverter operation to operate the power inverter, use the on / off switch on the front panel to turn the power on. Then the power inverter is ready to deliver ac power to your loads. If several loads are to be used, turn them on separately after the inverter is “on” in order...

  • Page 19: 4. Troubleshooting

    Www.Samlexpower.Com 4. Troubleshooting warning! Do not open or disassemble the inverter. Attempting to service the unit yourself may cause risk of electrical shock or fire. Problems and symptoms possible cause remedies “no ac power output” status of illumination of the red led a. Blinking fast over ...

  • Page 20: 5. Maintenance

    Www.Samlexpower.Com 5. Maintenance to keep your inverter operating properly, there is very little maintenance required. You should clean the exterior periodically with a damp cloth to prevent accumulation of dust and dirt. At the same time, tighten the screws on the dc input terminals. 6. Warranty w...

  • Page 21: Samlex America Inc.

    Www.Samlexpower.Com samlex america inc. 110-17 fawcett road, coquitlam, bc, v3k 6v2 canada toll free phone: 1-800-561-5885 toll free fax: 1-888-814-5210 general inquiries: samlex@samlexamerica.Com www: http://www.Samlexamerica.Com sa-2000k_manual_jan2010