Owner's manual please read this manual before operating your converter dc to dc step up converter model: vtc605.
Introduction step up a 12 vdc battery to between 13.5 and 17.0 or 24.0 and 27.5 vdc in 0.5 vdc increments (via 3 position dip switch), or stabilize a 12 or 24 vdc power system. Safety features include reverse input protection, low input voltage alarm, low output voltage alarm, over temperature shutd...
Important safety instructions save these instructions — this manual contains important safety and operating instructions for the converter. All converters 1) caution — to reduce risk of injury, charge only lead acid or sealed gel cell type rechargeable batteries. Other types of batteries may burst c...
Installation mounting mount the unit in a dry location. Allow at least 1 inch of clearance for adequate cooling. Power connection the unit is supplied with three foot power input leads. This should normally be adequate to connect to a source of power. If you must extend the cable: • use the smallest...
Operation turn the power switch on the front of the unit on to energize the outputs. To adjust the output voltage, turn off the power switch. Remove the plate from the top of the box. Reach in with a non-conductive device such as a pencil and open or close the dip switches as shown below to select t...
Dry contact relay to use your dry contact output fail relay you must connect a 9-pin d connector to the unit. You must use pins one and six as is indicated on page 6 in the remote connector diagram. The relay is factory preset to fail in the closed position when the low output led and buzzer come on...
Remote control option a remote control panel may be connected to the con- verter using a 9-pin d-connector, which attaches to the side of the converter. The remote control panel and d connector are part of the remote control option. The remote control panel allows the unit to be oper- ated remotely ...
