SamplexPower SRV-120-KIT Owner's Manual - page 11
11
7
SOLAR PANEL INSTALLATION
7. To install the Well-Nuts, drill holes 1¼” deep at the marked positions using a ½” size drill bit. Make sure
that drilling does not interfere with pre-existing wiring installations.
8. Apply silicone or any appropriate sealant recommended by your RV dealer generously to the drilled
holes for water-proofing.
9. Insert the ¼” Well-Nut into the drilled holes so that only the flange section remains above the roof
surface.
10. Fasten the mounting brackets to the roof surface by inserting the ¼ x1¼” serrated flange bolt into the
Well-Nut. Tighten using a3/8” wrench to a recommended torque of 15 lbs. When the serrated flange
bolt is screwed into the Well-Nut, the material surrounding the well nut bulges slightly securing the
structure to the RV roof.
11. Make sure all bolts and mounting brackets are covered by good amounts of suitable RV sealant
recommended by your local RV dealer.
Fig. 7.8 Attaching 5-hole
mounting bracket to RV Roof
Rubber bushing material expands
when bolt is tightened to securely
anchor hardware
solar
module
¼”-20 x 1¼” flange bolt
¼” flat washer
Well-Nut
mounting bracket
RV roof material
up to approx. 3/8”
thickness