Samson Airline 88 Owner's Manual - Quick Start

AirLine 88 Headset Wireless System

5

In order for your wireless system to work correctly, both the receiver and transmitter must be set to 

the same channel. Follow this basic procedure for setting up and using your AirLine 88 Headset 

wireless system:

Physically place the CR88 receiver where it will be used, and extend the antennas 

vertically. The general rule of thumb is to maintain “line of sight” between the receiver 

and transmitter so that the person using or wearing the transmitter can see the receiver.

With the CR88 powered off, connect the included power adapter. Turn the CR88 on 

momentarily to confirm that the unit is receiving power. You’ll see the LED display light 

up. Then turn the CR88 power off.

With your amplifier or mixer off 

and volume control all the way 

down, connect the CR88 receiver 

output jack to the mic or line 

level input of a mixer or amplifier 

using the balanced XLR output or 

unbalanced ¼” line level output. 

Turn the Level knob on the CR88 

completely counterclockwise, then 

turn its power on.

Quick Start

This device complies with Part 15 of the 

FCC Rules. Operation is subject to the 

following two conditions:

(1) This device may not cause harmful 

       interference, and

(2) this device must accept any 

       interference received, including

       interference that may cause

       undesired operation.  

FREQ:

542-566MHz

Make sure the AH8 Headset transmitter 

is fully charged (see section 

Charging the 

AH8 Transmitter) Turn on the power to the 

transmitter by pressing and holding the 

Power button for 3 seconds; the indicator 

LED will light yellow when the button is 

pressed and turns green when released and 

the AH8 is powered on. 

This device complies with Part 15 of the 

FCC Rules. Operation is subject to the 

following two conditions:

(1) This device may not cause harmful 

       interference, and

(2) this device must accept any 

       interference received, including

       interference that may cause

       undesired operation.  

FREQ:

542-566MHz

This device complies with Part 15 of the 

FCC Rules. Operation is subject to the 

following two conditions:

(1) This device may not cause harmful 

       interference, and

(2) this device must accept any 

       interference received, including

       interference that may cause

       undesired operation.  

FREQ:

542-566MHz

3. Plug in receiver

4. Turn on receiver

5. Plug receiver into audio system

6. Press Select button to change channel

9. Press and hold SELECT button to IR set

10. Adjust Volume control

7. Install batteries

8. Press button on transmitter to turn on

9. Press and hold Select button to IR set

7. Install batteries

8. Turn on belt pack transmitter

Press the SELECT button on the front of 

the CR88 receiver to choose an available 

channel. The channel number will increase 

by one digit, from 0-9 then A-F. Once the 

last channel has been reached, the count 

will cycle back to 0.