Samson AK115 Owner's Manual

Manual is about: BASS ENCLOSURES, AK SERIES

Summary of AK115

  • Page 1

    Bass enclosures series ak410 ak115.

  • Page 3

    Copyright 2012, samson technologies corp. V2 hartke 45 gilpin avenue hauppauge, new york 11788-8816 phone: 1-800-3-samson (1-800-372-6766) fax: 631-784-2201 www.Hartke.Com.

  • Page 4: Table Of Contents

    1 table of contents introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 ak series enclosures features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 about impedance and power handling . . . . . . . . . . . . . . . . . . . . . . . 3 connecting ...

  • Page 5: Introduction

    1 introduction thank you for purchasing the ak series bass enclosure from hartke! We know you don’t like reading owners manuals, but you’ve just purchased one of the finest bass speaker systems around, and we want to tell you about it. So, before you plug in and start popping and slapping, we’d like...

  • Page 6: Ak Series Features

    2 3 ak series features ak115 features • 1 x 400 watt, 15-inch, heavy-duty, paper cone low frequency driver with ceramic motor • 1-inch, titanium, high frequency com- pression driver with level control • precision tuned, vented enclosure • 400 watt power handling • 8-ohm impedance • 3/4" birch plywoo...

  • Page 7: About Impedance

    2 3 about impedance and power handling about impedance before you hook up your speaker cabinet, be sure that you understand a little about impedance. Impedance is the electronic load that the speaker puts on the power amplifier and is measured in ohms. Too much of a load (indicated by lower impedanc...

  • Page 8

    4 5 important : there is a minimum safe impedance so be sure to check the manu- facturer’s recommended impedance for your amplifier to avoid any damage to your amplifier or voiding your warranty. Connecting the ak410 and ak115 to your amplifier the ak410 and ak115 connections are made via either the...

  • Page 9

    4 5 using the high frequency level control using the high frequency level control your ak series cabinet has a control used to adjust the level of high frequency compression driver. The switch has three positions, on, -6db and off. When the switch is set to off, the compression driver is completely ...

  • Page 10: Specifications

    6 ak410 specifications type 2 chamber, sealed enclosure system impedance 8 ohms low frequency drivers 4 x 125 watt, 10", paper cone drivers high frequency driver 1" titanium compression driver with level control power handling 500 watts rms frequency response 42hz - 18khz dimensions (h x w x d) 25" ...

  • Page 11

    6.

  • Page 12

    45 gilpin avenue hauppauge, new york 11788-8816 phone: 1-800-3-samson (1-800-372-6766) fax: 631-784-2201 www.Hartke.Com.