Summary of Conert 277
Page 3
Copyright 2009, samson technologies corp. Printed, january 2009 v1 samson technologies corp. 45 gilpin avenue hauppauge, new york 11788-8816 phone: 1-800-3-samson (1-800-372-6766) fax: 631-784-2201 www.Samsontech.Com.
Page 4: Table of Contents
Table of contents introduction / system features. . . . . . . . . . . . . . . . . . . . . . . . . 1 system features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 guided tour - cr277 front panel. . . . . . . . . . . . . . . . . . . . . . . . 3 guided tour - cr277 rear panel . ...
Page 5
1 1 introduction / system features congratulations on purchasing the samson cr277 dual microphone wireless system! The cr277 system is the perfect solution for any application requiring two, high quality, wireless microphones in a compact package. The system features the cr277 dual channel, diversit...
Page 6: System Features
22 system features designed for use in both live sound and sound contracting applications, the samson concert series wireless system provides a high performance, cost effective solution, utilizing state-of-the-art technology in wireless communications. Main features include: • six different availabl...
Page 7
3 guided tour - cr277 front panel 1: antennas (channels a and b) - the antenna mountings allow full rotation for optimum placement. In normal operation, both antenna a (the antenna on the left) and antenna b (the antenna on the right) should be placed in a vertical position. Both antennas can be fol...
Page 8
4 1: mix out switch - sets the output b balanced output to send either the combined signal for channel a and b when the switch is in the "on" position, or to just channel b when in the "off" position. See the “setting up and using the concert series system” section on page 6 in this manual for more ...
Page 9: Guided Tour - Ht7
5 guided tour - ht7 1: audio on-off switch - when set to the “on” position, audio signal is transmitted. When set to the “off” position, the audio signal is muted. Because the carrier signal remains during muting, no “pop” or “thud” will be heard. Note that turning this off does not turn off the tra...
Page 10: Setting Up and Using The
6 setting up and using the concert series system * be sure to mute the audio signal at your external mixer or amplifier before turning transmitter(s) power on or off, or an audible pop may result. The basic procedure for setting up and using your concert series wireless system takes only a few minut...
Page 11: Setting Up and Using The
7 setting up and using the concert series system 8. Turn on the power to one of the ht7 transmitter (using its power on-off switch); the green “high” battery strength led will light if the battery is sufficiently strong. At this point, a few segments in the cr277 front panel rf level meter should li...
Page 12: Setting Up and Using The
88 setting up and using the concert series system 12. Temporarily turn down the level of your mixer/amplifier system and turn off the power to your transmitter, leaving the cr277 on. Then restore the previously set level of your mixer/ampli- fier. With the transmitter off, the receiver output should...
Page 13: Specifications
9 specifications system specifications channels n:6, u:6, e:4, b:4 frequency type f3 modulation type fm noise reduction type compander/expander distance 300 feet transmitter (ht7) oscillation type direct pll pre-emphasis 50 µsec antenna integral antenna maximum input level 3 v p-p battery type durac...
Page 14: Concert Series Frequency
10 concert series frequency conversion chart.
Page 15: Fcc Rules and Regulations
Fcc rules and regulations samson wireless receivers are certified under fcc rules part 15 and transmitters are certified under fcc rules part 74. Licensing of samson equipment is the user’s responsibility and licensability depends on the user’s classification, appli- cation and frequency selected. T...
Page 16
Samson technologies corp. 45 gilpin avenue hauppauge, new york 11788-8816 phone: 1-800-3-samson (1-800-372-6766) fax: 631-784-2201 www.Samsontech.Com.