Samson Expedition Escape Owner's Manual - Using A Microphone
8
Using a microphone
•
Set the Expedition Escape's power switch to the
OFF position, and fully turn
the volumes controls counterclockwise to
0.
•
If an outlet is available, connect the included power cord to the
AC INPUT
of the speaker, and plug it in.
•
Connect a microphone using a
1
⁄
4
" cable to the
MIC INPUT.
•
Switch on the Expedition Escape power.
•
While speaking into the microphone, slowly raise the channel
MIC until you
have reached the desired level.
NOTE: If not using the MIC input, turn the volume control all the way down to keep
out any unwanted noise.
Pairing with a Bluetooth® device
• Turn all MASTER VOLUME
control all
down counterclockwise to
0.
• With the Expedition Escape and your
Bluetooth
device powered on; press the
PAIR button on the rear panel of the
Expedition Escape speaker to make the
speaker discoverable. The
Bluetooth
indicator will slowly flash blue.
• In the settings of your
Bluetooth
device, set it to “discover” available
devices.
• From the
Bluetooth
device list, select
the "Samson Escape" device.
• If your device asks for a passkey, enter digits 0000 (four zeros) and press
OK. Some devices may also ask you to accept the connection.
• As the Expedition Escape is connecting to your device, the
Bluetooth
indicator will quickly flash blue.
• The Expedition Escape speaker indicates that pairing is complete when the
indicator turns steady blue. You can now stream audio from your device to
the Expedition Escape speakers.
• With the volume control on your
Bluetooth
device turned up, play some
music, and slowly raise the Expedition Escape channel
MASTER VOL control
until you have reached the desired level.