1. DL manuals
  2. Samson
  3. Transmitter
  4. Stage 5
  5. Owner's Manual

Samson Stage 5 Owner's Manual

Other manuals for Stage 5: Owner's Manual
Manual is about: True Diversity Wireless System

Summary of Stage 5

  • Page 1

    W i r e l e s s and w i r e l e s s s y s t e m t r u e d i v e r s i t y w i r e l e s s s y s t e m.

  • Page 2

    Copyright 2002, samson technologies corp. Printed september 2002 samson technologies corp. 575 underhill blvd. P.O. Box 9031 syosset, ny 11791-9031 phone: 1-800-3-samson (1-800-372-6766) fax: 516-364-3888 table of contents introduction 3 guided tour - sr55 receiver front panel 5 guided tour - sr55 r...

  • Page 3

    3 introduction congratulations on purchasing the samson stage 55 series or stage 5 series wireless system! Although this product is designed for easy operation, we suggest you first take some time to go through these pages so you can fully understand how we’ve implemented a number of unique features...

  • Page 4

    4 introduction in this manual, you’ll find a more detailed description of the features of your stage 55 series or stage 5 series system, as well as a guided tour through all components, step- by-step instructions for setting up and using your system and full specifications. If your stage 55 series o...

  • Page 5

    5 guided tour - sr55 front panel 1: antennas (a and b) - the antenna mountings allow full rotation for optimum placement. In normal operation, both antenna a (the antenna on the left) and antenna b (the antenna on the right) should be placed in a vertical position. Both antennas can be folded inward...

  • Page 6

    6 guided tour - sr55 rear panel 1: dc input - connect the supplied 12 volt, 250 ma power adapter here, using the strain relief as shown in the illustration below. Warning: the substitution of any other kind of power adapter can cause severe damage to the sr55 and will void your warranty. 2: balanced...

  • Page 7

    7 guided tour - sr5 front panel 1: antenna - the antenna mounting allows full rotation for optimum placement. In normal operation, the antenna should be placed in a vertical position. It also can be folded inward for convenience when transporting the sr5. See the “setting up and using your stage 55 ...

  • Page 8

    8 guided tour - sr5 rear panel 1: dc input - connect the supplied 12 volt, 250 ma power adapter here, using the strain relief as shown in the illustration below. Warning: the substitution of any other kind of power adapter can cause severe damage to the sr5 and will void your warranty. 2: balanced o...

  • Page 9

    9 guided tour - sr5 / st5 1: input connector - the input device is connected here. The st5 is supplied with either a lavaliere, headset microphone or heavy-duty instrument cable terminating with a 1/4" plug, which are all connected to the transmitter via a locking 3.5mm mini-phone jack. 2: battery l...

  • Page 10

    10 guided tour - sr5 / st5 5: power on-off switch* - use this to turn the st5 on or off (to conserve battery power, be sure to leave it off when not in use). 6: attenuation switch - the st5 transmitter features a signal attenuation switch that is used to select the input level of “0db” or “-15db”. T...

  • Page 11: Ch2

    11 guided tour - ht5 1: audio on-off switch - when set to the “on” position, audio signal is transmitted. When set to the “off” position, the audio signal is muted. Because the carrier signal remains during muting, no “pop” or “thud” will be heard. Note that turning this off does not turn off the tr...

  • Page 12

    12 setting up and using your stage 55 series/stage 5 series system the basic procedure for setting up and using your stage 55 series or stage 5 series wireless system takes only a few minutes: 1. For the stage 55 series / stage 5 series system to work correctly, both the receiver and transmitter mus...

  • Page 13

    13 setting up and using your stage 55 series/stage 5 series system 9. Now it’s time to set the audio levels. Turn on your connected amplifier and/or mixer but keep its volume all the way down. Next, make sure that your transmitter is unmuted by setting its audio switch to “on.” then set the volume k...

  • Page 14

    14 setting up and using your stage 55 series/stage 5 series system 11. Conversely, if you hear a weak, noisy signal at the desired volume level (and with the volume control of the receiver turned fully clockwise), again make sure that the sr55 or sr5 rear panel audio output level switch is set corre...

  • Page 15

    Appendix a: carrying case to ensure the longevity of your stage 55 series / stage 5 series system, and for conve- nience when on the road, your stage 55 series / stage 5 series system includes an impact-resistant polypropylene plastic carrying case with foam rubber padding. As shown in the illustrat...

  • Page 16

    16 specifications transmitter (st5 and ht5): transmission mode frequency modulation, 80kf3e, 15 khz peak deviation frequency range 173.80 mhz to 213.20 mhz, 25 frequencies band a (european / uk models) 160.10 to 177.90 mhz band b (european / uk models) 189.10 to 210.10 mhz osc system crystal control...

  • Page 17: Industry & Science Canada.

    Fcc rules and regulations samson wireless systems are type accepted under fcc rules parts 90, 74 and 15. Licensing of samson equipment is the user’s responsibility and licensability depends on the user’s classification, application and frequency selected. This device complies with rss-210 of industr...