Samson Stage XPD1 Quick Start Manual - Stage Xpd1 Controls
Stage XPD1 Controls
1. Input Connector - Connect the input device via the mini-XLR connector. The PXD1 is supplied with
either a lavalier or headset microphone.
2. Status Indicator - This LED displays the operation mode:
Amber
Normal Operation
Flashing Amber
Pairing/Low Battery
3. Power/Pair Switch - Press <5 seconds to turn the unit on or off. Press >5 seconds to enter pairing
mode.
4. Input GAIN Control - This control adjusts the transmitter input sensitivity.
5. Battery Holder - Insert two standard AA (LR6) batteries here, being sure to observe the plus and
minus polarity markings shown. Although rechargeable Ni-Cad batteries can be used, they do not
supply adequate current for more than four hours. WARNING: Do not insert the batteries backwards;
doing so can cause severe damage to the PXD1 and will void your warranty.
6. Plastic Screwdriver - Used to adjust the input GAIN control.
7. USB Connector - Plugs into the USB jack on the rear panel of a wirelessly enabled Samson audio
device. The receiver can also plug directly into a computer USB port and will be recognized as a USB
audio device. The unit passes audio to the device and receives power from the device through this
connector.
8. PAIR Switch - Press >5 seconds to enter pairing mode.
9. STATUS Indicator - This LED displays the operation mode:
Amber
Normal Operation
Flashing Amber
Pairing
No Light
Not Paired; Transmitter Out Of Range; No Power
1
2
3
4
5
6
7
8
9