Samsung ACN016NDEHA Installation Manual - page 13
13
ENGLISH
Connecting the connection cord
t "MXBZTSFNFNCFSUPDPOOFDUUIFSFGSJHFSBOUQJQFTCFGPSFQFSGPSNJOHUIFFMFDUSJDDPOOFDUJPOT
8IFOEJTDPOOFDUJOHUIFTZTUFNBMXBZTEJTDPOOFDUUIFFMFDUSJDDBCMFTCFGPSFEJTDPOOFDUJOHUIFSFGSJHFSBOUQJQFT
t "MXBZTSFNFNCFSUPDPOOFDUUIFBJSDPOEJUJPOFSUPUIFHSPVOEJOHTZTUFNCFGPSFQFSGPSNJOH
the electric connections.
The indoor unit is powered by the outdoor unit by means of a H07 RN-F connection cable (or a more power model),
with insulation in synthetic rubber and jacket in polychloroprene(neoprene), in accordance with the requirements of standard EN 60335-2-40.
1. Remove the screw on the electrical component box and remove the cover plate.
2. Route the connection cord through the side of the indoor unit and connect the cable to terminals; refer to the figure below.
3. Route the other end of the cable to the outdoor unit through the ceiling & the hole on the wall.
4. Reassemble the electrical component box cover, carefully tightening the screw.
Indoor Power supply
Communication Cable
Power Supply
.BY.JO 7
Indoor Power cable
7_)[
0.75~1.5mm²,3wires
0.75~1.5mm²,2wires
J
'PSDPOOFDUJPODBCMFVTFUIFHSBEF)3/'PS)3/'NBUFSJBMT
J
4DSFXTPOUFSNJOBMCMPDLNVTUOPUCFVOTDSFXFEXJUIUIFUPSRVFMFTTUIBOLHGtDN
J
4JODFJUIBTUIFFYUFSOBMQPXFSTVQQMZSFGFSUPUIFPVUEPPSVOJUJOTUBMMBUJPONBOVBMGPS."*/108&3
Wiring diagram
1 phase
1(L) 2(N)
N
L
F3
F4
V1
V2
Indoor Unit
Main power cable
Cable clamp
Indoor Power
Communication cable
L
F2
F1
N
Cable tie
Between Indoor and Outdoor Connection cable Specifications(Common in use)
Terminal Block SPEC (Indoor)
8IFOJOTUBMMJOHUIFJOEPPSVOJUJOBDPNQVUFSSPPNVTFUIF
EPVCMFTIJFMEFE 5BQFBMVNJOVNQPMZFTUFSCSBJEDPQQFS
cable of FROHH2R type.
"$108&3.4$3&8
11
13
$0..6/*$"5*0/.4$3&8
7.5
9.0
13.8
18
5JHIUFOJOH5PSRVF LHGtDN
M3.5
8.0~10.0
M4
12.0~15.0
If using a multi system, refer to the manual supplied with the outdoor unit.
V1
V2
F3
F4
Wired Remote
Controller(Optional)