Samsung Air Conditioner User Manual - page 10
9
EN
G
LIS
H
2) Connecting network with WPS setting
2
1-2
1-1
(1) After pressing the [2
nd
F] button on the remote controller, press the [WPS] button.
message will be displayed on the front display panel of the air conditioner.
(2) Press [WPS] button on the wireless router that will be connected to an air conditioner and operate the WPS function of
the wireless router. (The location of WPS button may be different depending on the wireless manufacturing company.)
(3) After connecting the air conditioner with the wireless router correctly, the Wi-Fi (
) light on the Wi-Fi module will be
on.
• Check whether the wireless router supports Wi-Fi Protected Setup™(WPS).
• Check whether the wireless router has WPS button.
• Samsung smart air conditioner uses PBC method of WPS.
• When searching a network by pressing [WPS] button, the remote controller will not work for a maximum of 2
minutes.
• Be careful when pressing the WPS button because if you hold the WPS button for a long time, the set value of the
wireless router will be initialized with some types of wireless router.
• Operating wireless router through WPS mode might be different depending on the manufacturing company.
Therefore, please refer to the user manual of your wireless router.
• If the wireless router(AP) is not authenticated with WPS, connection failure might occur.
• If the wireless router that is not authenticated with WPS is connected to an air conditioner, the previously
connected Wi-Fi of other units might be disconnected.
NOTE
CAUTION
융프라우 수출향 RAC APP_IB_E_34261A(2).indd 9
2012-02-17 오후 2:10:16