Sensoray co., inc. Pci frame grabber model 611 (rev.D) july 2001 sensoray 2001 7313 sw tech center dr. Tigard, or 97223 phone 503.684.8073 • fax 503.684.8164 sales@sensoray.Com www.Sensoray.Com.
2 table of contents limited warranty ..................................................................................................3 special handling instructions............................................................................4 introduction ..............................................
3 limited warranty sensoray company, incorporated (sensoray) warrants the hardware to be free from defects in material and workmanship and perform to applicable published sensoray specifications for two years from the date of shipment to purchaser. Sensoray will, at its option, repair or replace equ...
4 special handling instructions the circuit board contains cmos circuitry that is sensitive to electrostatic discharge (esd). Special care should be taken in handling, transporting, and installing circuit board to prevent esd damage to the board. In particular: • do not remove the circuit board from...
5 specifications video sources ntsc, pal, secam, rs-170, ccir video inputs 4 analog composite video; 1 analog y/c (s-video) [1] . Output formats rgb (15, 16, 24, 32 bits/pixel), y8 (8 bits/pixel), ycrcb (16 bits/pixel) output resolution (max), pixels 754x480 (ntsc, rs-170), 922x576 (pal, secam, ccir...
6 connectors video inputs: j1 composite video 1 j2 composite video 2 j3 composite video 3 j4 composite video 4 p1 s-video (y/c) notes: 1. Composite video 4 and s-video inputs share the same physical line. Do not connect video sources to both at the same time..
7 gpio connector (j5) pin signal pin signal 1 ground 2 gpint 3 gpo2 4 gpo3 5 gpo0 6 gpo1 7 gpi2 8 gpi3 9 gpi0 10 gpi1 notes: 1. Gpo0-gpo3 – cmos outputs. 2. Gpi1-cpi3 – cmos inputs. 3. Gpint – general purpose interrupt pin..
