Sensorio LZR-U905 User Manual - Mounting
of
8
4
1
5
6
7
8
1
2
3
4
MOUNTING
Use the adhesive mounting
template to position the
sensor correctly. The grey
area indicates the detection
range.
Drill 4 holes as indicated
on the mounting template.
Make a hole for the cable if
possible.
Pass the cable +/- 10 cm
though the cable opening.
If drilling an opening is
not possible, use the cable
conduits on the back side of
the bracket.
Position the bracket and
fasten the 4 screws firmly.
Open the protection cover,
plug the connector and
position the cable in the slit.
Close the protection cover
and fasten it firmly.
Turn the sensor until the two
triangles are face to face.
Position the housing on
the bracket.
INSTALLATION STEPS