Sentinel CCTV RV56 Installation & Operation Manual - Camera Installation
1. At the desired camera mounting position, fit the camera mounting bracket
into position using the supplied screws on the center hole and slide hole.
2. Turn the bracket left and right to a correct direction and then tighten the
screws.
3. Fit the camera to the bracket using the supplied washers, spring washers
and screws.
4. Rotate the camera up and down to a position that you can see the picture
you want clearly and then tighten the screws.
5. Drill a cable entry hole through the wall or a door or a window frame just
below the mounting bracket.
6. Pull the cable fully through the hole. Inside the protected property, attach
the extension cable to the cable from the camera. Run the extension
cable to the monitor position. Then shield the hole that you made.
IMPORTANT : Do not connect any camera to
the monitor while the monitor is switched on.
Camera Installation
-7-