Sentry US TV8T-700 Operational manual - page 4
4
Front View
Back Panel
①
HD Out (Gold-plated BNC Connector)
For HD signal output; CoC (Control over Coax) technology supported.
②
OSD Control Buttons
ENTER button
UP & DOWN buttons
LEFT & RIGHT buttons
③
Video Out (BNC Connector)
For analog composite video TV signal output.
④
Communication Port
1. NC: Not Connected (No effect)
2. NC: Not Connected (No effect)
3. Day & Night External Input (controlled by external infrared illuminator)
4. Day & Night Output
5. ALO: Alarm Output
6. GND: Ground
⑤
Power LED (Power Input Indicator)
When the camera is connected to a power supply, the indicator light will be on.
⑥
Power Input Terminal
Connect to the power supply of 12Vdc.
OSD
A. CAMERA OSD
To operate the camera OSD setting, use the control key pad to control it. For some models, you might need to
open the control panel case to access the control key panel. Press the Enter button which in the center of the
control panel to bring up the "MENU" on the TV/Monitor screen as below. Please check the OSD content tables to
find out the function you need.
①
Light Sensor: Keep clear the front of
the sensor. If the sensor is covered, the
camera will switch to B/W mode
automatically.
②
Microphone
①
②
③
④
⑤
⑥