Senville SENL09HD Manual - page 5
Indicators on LCD
Transmission Indicator
Temp. display
Time display
Fan speed display
Sleep Display
Mode display
ON/OFF display
This transmission indicator lights when remote
controller transmits signals to the indoor unit.
Displays the current operation mode. Including
AUTO(
), COOL(
), DRY(
), HEAT(
)
(Not applicable to cooling only models), FAN(
)
and back to AUTO(
).
Displays the temperature setting(17 C~30 C/
). When you set the operating mode to FAN, no
temperature setting is displayed.
O
O
62 F~
86 F
O
O
Displayed by pressing the ON/OFF button.
Press the ON/OFF button again to remove.
Indicate Timer on/off time(0:00~23:50 hours) or clock
time. The clock time is indicated only when no AUTO-
ON/OFF timer is set. When AUTO-TIMER feature is
operating, it displays the AUTO-ON/OFF time. To
check the current time, press the CLOCK button, and
the time will display.
Displays the selected fan speed, AUTO(
) and three
fan speed levels
"
(HIGH) can be indicated. The fan speed
"
is auto controlled under AUTO or DRY mode.
Displayed under sleeping operation.
Press the SLEEP button again to remove.
Note:
All displays on the remote controller are
shown for illustration purposes only.
(LOW) "
" (MED)
"
"
Lock Display
Displayed when LOCK mode is activated.
AUTO
COO L
DRY
HE AT
FAN
E
TEMP.
SE T
CLOCK
TI MER
HOUR
ON
OFF
AUTO
1
Static electricity or other factors (Voltage transients) can
cause the remote controller clock to initialize. If your
remote controller is initialized (the time of
flashing), readjust the clock before starting the unit.
"12:00"
CAUTION
!
How to use the buttons
2
Before you start operating the air conditioner, set
the clock of the remote controller using the proce-
dures given in this section. The clock panel on the
remote controller will display the time regardless of
whether the air conditioner is in use or not.
After batteries are inserted in the remote controller,
the clock panel will display "12:00" and begin to flash.
Press these buttons to set time.
Forward.
Backward.
Each time you press the button, the time moves
forward or backward by one minute depending
on which side you press. The time alters as quickly
as you push the button.
Keep pressing the button without releasing, the
time moves forward or backward by 10 minutes
depending on which side you press.
1. UP/DOWN button
Initial Setting the Clock
.
.
When the right time is achieved, press the CLOCK
button or release the
or
and wait for 5
seconds, the clock time stops flashing and the
clock starts operating.
Press the CLOCK button on the remote controller,
the time of the clock display will start to flash. To
set the new time, follow 1 and 2 of "Initial Setting
of the Clock".
The time of the CLOCK must be set before
the AUTO-TIMER feature will operate.
Note:
* Clock accuracy is within 15 seconds per day.
2.
3.Readjusting the Clock
.
CLOCK button
MODE
FAN SPEE D
SWI NG V
S LEE P
TIMER ON
TIMER OFF
CLOCK
R ESET LOCK
AUTO
CO OL
D RY
H EAT
FAN
E
TEMP.
SET
CLOC K
T IMER
HO UR
O N
OFF
M