Senztek solastat-1 User Manual - page 5
SolaStat™-1-3 User Guide
Version 1.0 – April 2011
Page 2
T
HE
D
ISPLAY
P
ANEL
Helping you
to achieve
Power
Savings
Your SolaStat™ helps you save power by controlling the amount of hot water
that enters your tank.
Your SolaStat™ is set to make the pump automatically turn on or turn off,
depending on the temperature in the tank and at the collector.
You can manually alter the amount of water entering your tank by using the
PUMP button.
The ROOF, TANK
and INLET lights
indicate which
temperature is being
displayed.
If any of these lights
flashes, the unit is in
Smart Shutdown mode
and SSd will be
displayed.
NEXT Button
Press to obtain the next
displayed temperature.
The DISPLAY PANEL
shows the temperatures
of the relevant sensors in
0
C or
0
F.
PUMP Button
Press and hold this
button to turn the
pump on. Repeat this
again to turn the pump
off.
After the pump has run
for ten minutes, it
automatically switches
off for one minute, to
let air escape and
prevent overheating
When in
Programming Mode,
use this to increase
the display value on
the screen.
HWC Button
Normally used to activate a one-off heat up
of the Hot water cylinder element.
Note that this is not active in this model.
When in Programming Mode, use this
button to decrease the display value on the
screen.
TEST Button
Press to test the display of the screen. ‘888’ will be
displayed and all the lights (except the PWR light)
will be on at the same time for about two seconds.
All the lights will then flash and the display will show
the number of times the pump has been on (up to
999).
The PUMP light comes on when the
pump is on (in normal or FROST
operation or when the PUMP button is
pressed).
The PUMP light flashes when the
maximum tank temperature has been
reached.
HWC
The HWC light is
not active in this
model.
The TOPOUT
light is on when
the hot water tank
has reached its
maximum
temperature.
The FROST (and PUMP)
light is on when the pump is
circulating water to stop the
collector from freezing.
CAUTION: Do not turn the
power off when the
FROST light is on.