SEON WIreless Microphone and Controller Quick Start Manual - page 3
3
6
Charging
For a full charge, leave the bodypack in the base with the belt clip
facing out for 4 hours.
1 If the red Low Batt light starts flashing or if the bodypack
vibrates, return the bodypack to the base to fully charge the
bodypack.
The
CHARGE
light illuminates constant green when the unit is
fully charged.
2 The base stays powered on for four hours after the vehicle
ignition is turned off to charge the bodypack.
Recommendations
Beep Options
All of the audible beep signals on the bodypack can be enabled by
setting the beep switch to the
BEEP
position.
Note: The switch underneath the flexible cover should be set to M.
The switch is for future use
Out of Range
1 If you use the bodypack too far away from the base during
recording, the bodypack will vibrate or if beep is enabled, alert
you with audible warning beeps (two tones), and the red
IN
-
USE
light will blink.
2 Move closer to the receiver base and the link will be
reestablished once you return to normal range. The
IN
-
USE
light
will illuminate constant green when the link is back to normal
operation.
3 If the link is not reestablished within 30 seconds, the bodypack
and base will return to standby mode.
4 If you went out of range in standby mode, or the unit reverted
to standby mode, reenter the normal range and press the
IN
-
USE
button. Operation will return to normal.
5 If you will be out of range for a long period of time, turn the
bodypack off.
Using Multiple Wireless Systems
The wireless microphone system has 95 possible channels that are
really different frequency hopping schemes. Each synchronized
base and bodypack will automatically find a clear channel so up to
40 systems can work together in one location depending on
other interference problems.
Potential Sources of Interference
There are many potential sources of interference for your
wireless system. Any electronic product that contains digital
circuitry including digital signal processors (reverb/multi-
effects units), electronic keyboards, digital lighting controllers,
CD and DVD players, and computers, all emit RF energy that
can adversely affect the performance of your wireless system.
It is always best to place the receiver as far away as possible
from these devices to minimize potential problems.
The wireless microphone system operates in the 2.4MHz ISM
band and other devices in that band may interfere. The spread
spectrum technique used in the wireless microphone system is
very robust and should operate even in the presence of other
2.4MHz devices such as walkie-talkies, LANs, cordless phones
in the area.
Battery Recommendations
The lithium ion battery built into the bodypack will work at full
capacity for over 500 charge cycles. If you notice lower than
usual battery life over time, it may be time to replace the
bodypack.