4channel video server svg-3410 full manual 1 4-channel video server model: svg-3410 type c full manual (english) version 1.0
4channel video server svg-3410 full manual 2 warning the lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of ...
4channel video server svg-3410 full manual 3 warning this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential install...
4channel video server svg-3410 full manual 4 precautions 1. Heed warnings adhere to all warnings on the appliance and in the operating instructions. 2. Power sources operate this equipment only from the type of power source indicated on the label. If you are not sure of the type of power being used,...
4channel video server svg-3410 full manual 5 12. Important note to the installer this installation should be made by a qualified service person and should conform to all local codes. In order to provide this product with protection against risk of unintentional operation by employees, customers, jan...
4channel video server svg-3410 full manual 6 table of contents 1. Introduction of svg-3410 ............................................................................................... 8 1.1. Product overview ............................................................................................
4channel video server svg-3410 full manual 7 5.3. Event setting ......................................................................................................... 37 5.4. Network setting..................................................................................................... 40 5....
4channel video server svg-3410 full manual 8 1. Introduction of svg-3410 1.1. Product overview • about the video server svg-3410 is a highly sophisticated network video server with the embedded linux operating system. The equipment is capable of receiving analog video and audio input from four chann...
4channel video server svg-3410 full manual 9 • embedded motion detection function svg-3410 has an embedded sensor system that detects movements. The user can setup the motion detection mode on the viewer. The observing areas of motion and sensitivity can be regulated according to the user’s need. Th...
4channel video server svg-3410 full manual 10 1.3. Features built-in web server and network interface no pc needed for operation – standalone unit linux based operating system motion detection : adaptive detection level setting monitor live video transmitted in real-time - remote monitorin...
4channel video server svg-3410 full manual 11 1.4. Packing contents network video decoder cross lan cable cd-rom with manual and software dc adapter(12v/1a) * separate sale power cable +terminal block 2p terminal block 5p 1.5. System requirements operating system : microsoft windows® 2000 or windo...
4channel video server svg-3410 full manual 12 1.6. System configuration.
4channel video server svg-3410 full manual 13 1.7. Physical description 1.7.1. Front view 1) pwr : power supply status is displayed (red led on) 2) act : 4channel video server action led (orange led blink) 3) lan: when data is transmitted and received through the lan port, the led blinks. 4) usb por...
4channel video server svg-3410 full manual 14 1.7.2. Rear view 1) alarm out : ttl level output 2) rs485 : rs485 data 3) alarm in : ttl level input 4) dc 12v : dc12v, 1ma 5) lan : rj-45 ethernet connector 6) video ch1 : 1vp-p composite, 1channel 7) audio ch1 : mono audio input & output, 1channel 8) v...
4channel video server svg-3410 full manual 15 2. Installation of svg-3410 2.1. Installation • if you use network lan card in your pc, you can connect the server directly to a pc with a cross lan cable provided in the package. • on the assumption that both the user pc and svg-3410 are used under stat...
4channel video server svg-3410 full manual 16 4) supply power on the camera and svg-3410 ( be sure to use exclusive power adapter - ④) 5) wait about 2 minutes after power is on the svg-3410 video server. The light on link led shows that the system is booted successfully. 2.2. Network setting of a pc...
4channel video server svg-3410 full manual 17 2) click local area connection 3) check the properties of internet protocol [tcp/ip].
4channel video server svg-3410 full manual 18 network setting of user pc 4) setup ip address, subnet mask and gateway in the user pc with 192.168.1.50, 255.255.255.0 and 192.168.1.1 as it is shown in the picture above. • caution - to activate svg-3410, the user pc must have the same network setup st...
4channel video server svg-3410 full manual 19 • after network setting of a pc, you can verify the network status as following: 1) go to ’start’ -> ‘run’ ->input ‘cmd’ 2) when a dos window appears as above, input 'ipconfig'. 3) the display shows the current network setting of a pc. 2.2.2. Operation o...
4channel video server svg-3410 full manual 20 3) click ‘install’. 4) when installation of ‘vg3xview-viewer' is completed, the initial log-in page appears . User log-in page.
4channel video server svg-3410 full manual 21 5) when the log-in page appears, input id and password and click ‘connect’. - default id: admin - password: ser (‘s’:capital letter, ‘er’: small letter) 4ch web viewer 6) the web viewer appears and images of the camera display..
4channel video server svg-3410 full manual 22 3. Configuration of network environment 3.1. Check-up network environment and installation type ▶to install svg-3410 properly, basic understanding of network environment is required . 1) private line environment in a huge complex such as company, univers...
4channel video server svg-3410 full manual 23 ▶there are two types of installation: 1) install svg-3410 without an ip sharing device (router) : a router is not required, if a cable modem or leased line is used, 2) install svg-3410 with an ip sharing device (router) : a router is required under pppoe...
4channel video server svg-3410 full manual 24 3.2. Installation without a router 3.2.1. Basic network setup 1) after checking video, connect svg-3410 to a pc with a cross lan cable 2) cable connection and network setup should be done as shown in ‘2.1. Installation and 2.2 network setting’. 3) run a ...
4channel video server svg-3410 full manual 25 setting page 5) click ‘settings’, then ‘setting page’ displays. 6) select and click ‘network setting’. Input default ip address, subnet mask, default gateway of svg-3410. 7) dns address should be given. (->see 3.2.2. Dns setup.) 8) setup port numbers in ...
4channel video server svg-3410 full manual 26 - when video is seen, svg-3410 is correctly set up. - when video is not seen, check whether there might be ip confliction in the network, and - re-check the network set values both of svg-3410, and the user pc. 3.2.2. Dns setup ▶ network setting -> ‘gene...
4channel video server svg-3410 full manual 27 3.2.3. Ports setup port setting ▶ network setting -> ‘ports’ -> - setup port number in each line of port setting. ▶ the default port number is preset as follows: (the user can change the port number, if necessary; ->see 3.3.2->12 ) - http port (web conne...
4channel video server svg-3410 full manual 28 3.3. Installation with a router 3.3.1. Network setup with a router 1) after checking video, connect svg-3410 to a pc with a cross lan cable 2) cable connection and network setup should be done as shown in ‘ 2.1. Installation and 2.2 network setting ’. 3)...
4channel video server svg-3410 full manual 29 3.3.2. Check the configuration of a router, svg-3410 and pc example ▶ caution: gw of a pc and svg-3410 must accord with the ip of the router example wlan-router ip : 192.168.1.33 sn: 255.255.255.0 svg-3410 ip : 192.168.1.40 sn: 255.255.255.0 gw: 192.168....
4channel video server svg-3410 full manual 30 4. Display mode 4.1. Initial log-in screen 4.1.1. Installation of the web interface 1. Internet explorer browser starts. 2. When the activex code pops up, click ‘yes’, then a message window shows as below. . 3. Click ‘install’. 4. When installation of ‘v...
4channel video server svg-3410 full manual 31 4.1.2 . Initial log-in screen of svg-3410 ▶ admin/user login when the log-in page appears, input id and password and click ‘connect’. Initial log-in setting is: - default id: admin - password: ser (‘s’:capital letter, ‘er’: small letter) caution: only th...
4channel video server svg-3410 full manual 32 4.2. Live page 4.2.1. Screen mode to change the setting values, you can move into ‘settings’. In the ‘live page’, you can monitor video images transmitted from 4 channels. Two screen modes are available. You can select the types of monitoring. 1 ) screen...
4channel video server svg-3410 full manual 33 channel 1: displays video images of channel 1 on the screen. Channel 2: displays video images of channel 2 on the screen. Channel 3: displays video images of channel 3 on the screen. Channel 4: displays video images of channel 4 on the screen. 2) 4 scree...
4channel video server svg-3410 full manual 34 5. Admin setting mode 5.1. General setting general setting • date/time 1) server date : shows the date of operation 2) server time: shows real time of operation.
4channel video server svg-3410 full manual 35 5.2. Encoder setting encoder setting • mpeg-4 encoder 1) channel: 1~4 2) quality: you can adjust the quality of the live video. 500~1500kbps in the frame mode 500~1500kbps in the gop mode 3) frame rate: the frame rate can be setup. Ntsc : 30, 15, 10, 7.5...
4channel video server svg-3410 full manual 36 5) mode: the live video can be set alternatively in the frame or gop mode. 6) format: the video format can be setup when a camera is compatible with pal and ntsc. (usually, the format is selected automatically: pal/ntsc, according to the type of camera,)...
4channel video server svg-3410 full manual 37 5.3. Event setting event setting.
4channel video server svg-3410 full manual 38 -> after selecting the channel (1~4ch), event handling function can be set up • generals 1) pre event dwell time: when an alarm occurs, recording time before the occurrence of the alarm can be setup. (0~30sec.) 2) post event dwell time: when an alarm occ...
4channel video server svg-3410 full manual 39 • ftp server : the ip and directory of ftp server can be setup. The user id/ and password of ftp server can be setup. • e-mail : the user can assign the e-mail address to receive the notification when an event occurs. To activate this functionality, smtp...
4channel video server svg-3410 full manual 40 • on the e-mail mode - e-mail address: input email address of the receiver - smtp address: input smtp address of the sender * smtp (simple mail transfer protocol): a protocol for sending e-mail messages between servers. - user id / user password : input ...
4channel video server svg-3410 full manual 41 5.5. Service setting service setting • version information firmware version mac address: mac address of a video server • firmware update how to update firmware from a distance: 1) download the newest software from the web site which provides the firmware...
4channel video server svg-3410 full manual 42 video server. Caution: while update is in the process, do not close or re-open a window. Also power disconnection can cause fatal damage. 5.6. Interface setting interface setting • rs-485 1) title: less than 16 letters 2) protocol: select a manufacturer ...
4channel video server svg-3410 full manual 43 3) device id: shows a unique id of each camera 4) capabilty: according to the type of camera, some specific features can be set up and operated. Click the feature that the user wants to activate. ▶ ptz controller ▪ pan/tilt: if the camera supports ptz fu...
4channel video server svg-3410 full manual 44 ▪ preset: the user can designate interesting places and give a number. The number can be saved on the preset mode. ▪ system-command: according to the protocol of the camera, some specific features can be operated on the system command mode. 5) baudrate: ...
4channel video server svg-3410 full manual 45 5.7. Motion detect setting -channel: select the specific channel of svg-3410 for motion detect setup.. -use motion detect: with a click, the user can activate motion detection function. -sensitivity: user can set up the sensitivity of motion detection. -...
4channel video server svg-3410 full manual 46 5.8. User setting -- id: input user id -- password: input user password -- auth: select the user type (guest, operation user, observer, admin) -- add: if you want to add a new id on the user list, click ‘add’ -- modify: if you want to modify a user id, c...
4channel video server svg-3410 full manual 47 appendix a. Video server connection diagrams • connection with an led as visual indicator • relay connection.
4channel video server svg-3410 full manual 48 • other connection.
4channel video server svg-3410 full manual 49 appendix b. Technical specification of svg-3410 video server ntsc pal os linux 2.4 general video compression mpeg-4 image resolution 352x240, 160x144 160x96 352x288, 160x240 176x144 frame rate 30/15/10/7.5 fps 25/13/8/6/5 fps video out 4ch video& audio a...
4channel video server svg-3410 full manual 50 appendix c troubleshooting q. Video not displaying a. No electrical power: check electrical connections a. Incorrect ip address: check and correct the ip address a. User not authenticated: check user id and password a. Not connecting to network: check pc...
4channel video server svg-3410 full manual 51 seorim technology co., ltd #1001, daerung technotown vi, 493-6, gasan-dong, kumchun, seoul, korea, 153-803 tel: +82-2-2108-5860 fax: +82-2-2108-5869 e-mail: sales@seorimtech.Com http://www.Seorimtech.Com q. Cannot delete st4 file a. Cannot delete recorde...