Zigbee home monitoring gateway user guide.
I table of contents chapter 1 introduction ............................................................................................. 1 package contents .............................................................................................................. 1 specification ....................
1 chapter 1 introduction this chapter provides an overview of the zigbee home monitoring gate- way's features and capabilities. Congratulations on the purchase of your new zigbee home monitoring gateway. The zigbee home monitoring gateway is a consumer electronic device, which is used for home monit...
2 leds front-mounted leds the zigbee home monitoring gateway has 8 leds. Reset this button has two (2) functions: • reboot. When pressed and released, the zigbee home monitoring gateway will reboot (restart). • clear all data. This button can also be used to clear all data and restore all settings t...
3 wps • on (amber) - problem occurred while trying to enable the wps function. • on (green) - wps function is enabled. • flashing - data is being transmitted or received via the connection. Service • on (green)- open for sensor binding (add) • off - system is in ready mode, no sensor is needed to be...
4 rear panel wan port (10/100baset) connect the dsl or cable modem here. If your modem came with a cable, use the supplied cable. Otherwise, use a standard lan cable. Lan (1~4) port use standard lan cables (rj45 connectors) to connect your pcs to these ports. Usb (1~2) port the two connectors are us...
5 chapter 2 initial installation this chapter covers the software installation of the zigbee home monitoring gateway. Requirements • network cables. Use standard 10/100baset network (utp) cables with rj45 connectors. Procedure 1. Choose an installation site select a suitable place to install the zig...
7 • 1. Usb type a connector • 2. Lan port • 3. Wan port • 4. Expansion slot connectors • 5. Push buttons. • 6. Console port • 7. Leds • 8. Rt3662 processor • 9. Dc power jack.
8 console port connection guide for platform debugging, please locate the console cable accompanied with the development kit. Then follow the steps illustrated below: pin definition 1. Connect cable to console port 2. Execute minicom on linux host machine.
9 3. Press ctrl+a then z to enter minicom configuration 4. Set comm port to baud rate 57600, 8 data bits, no parity bits, and one stop bit..
10 chapter 4 fcc statement 4 this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment ge...
