Serene S2044 ROMA Installation And Operating Manual - Filter
5
Serene S2044 ROMA Space Heater
Filter
This heater is fitted with an air
filter to protect the heating
elements from dust and dirt. The
filter is removable and can be
fitted from either the left or right
hand side of the heater. To keep
the heater operating efficiently,
remove and clean the filter once
every six months. Ensure the
filter is always fitted before
operating the heater.
Safety Cutout
This heater is fitted with a thermal safety cutout device. In the case of
over-heating, the safety cutout automatically switches off the heating
elements and fan motor. As a result, the heater stops working but the
LED indicator stays on.
Note: If the heater switches off, the LED indicator may also turn off
when the room temperature reaches the thermostat setting.
If the safety cutout is activated:
1. Turn the heater off at the wall switch and leave to cool for
approximately 30 minutes.
2. Check the air filter and clean if necessary. Ensure the filter is
fitted again before operating the heater.
3. Eliminate any other possible reason for overheating (such as
obstacles in front of the air inlet and outlet grille).
4. Turn the heater on and check operation. If the heater still fails to
operate, contact your nearest authorised service agent.
Care
The heater is best wiped down from time to time with a damp cloth. Do
not use any abrasive cleaners.
Air Filter