SERTEL T-GPS-300 User Manual - page 17
USER'S MANUAL - SAFETY GUIDE
Please read the following points before servicing or installing.
•
Pre-installation checks - It is recommended that the unit be bench tested prior to
installation on the site.
•
Safety during installation or servicing - Particular care should be taken to isolate the
pan/tilt head in order to prevent operation while engineering work is being carried out. In
addition any ladder or other means of working on the receiver MUST NOT rest on the pan/tilt
head as it is possible for the head to move when not expected.
•
Safety check - Upon completion of any service or repairs to the unit, safety checks should
be performed to ensure that the unit is in proper operating condition.
•
Coax grounding - If an outside cable system is connected to the unit, be sure the cable
system is grounded.
•
Adhere to Safety Standards - All normal safety precautions as laid down by Indian
Standards and the Health and Safety at Work Act should be observed.
WARNING - TO PREVENT DANGER OF FIRE OR SHOCK, DO NOT EXPOSE THE INTERNAL
COMPONENTS OF THIS EQUIPMENT TO RAIN OR MOISTURE.
Damage requiring service - Servicing by qualified personnel should be carried out under
the following conditions,
(a)
If the unit does not operate normally by following the operating instructions.
(b)
If the unit has been dropped or the enclosure is damaged;
Replacement parts - If replacement parts are required, ensure that only replacement
parts recommended by the SERTEL are used.
AFTER SALES SERVICE
Please contact
sales@sertelelectronics.com/info@serteltelser.com M: 0 93850 - 90333.